提交 6b1e5a45 编写于 作者: H Hannes Reinecke 提交者: James Bottomley

[SCSI] remove check for 'resetting'

Field is now unused, so this is dead code.

[jejb: remove resetting and last_reset from Scsi_Host]
Signed-off-by: NHannes Reinecke <hare@suse.de>
Signed-off-by: NJames Bottomley <JBottomley@Parallels.com>
上级 53a8936c
......@@ -78,11 +78,6 @@ static void scsi_done(struct scsi_cmnd *cmd);
* Definitions and constants.
*/
#define MIN_RESET_DELAY (2*HZ)
/* Do not call reset on error if we just did a reset within 15 sec. */
#define MIN_RESET_PERIOD (15*HZ)
/*
* Note - the initial logging level can be set here to log events at boot time.
* After the system is up, you may enable logging via the /proc interface.
......@@ -658,7 +653,6 @@ EXPORT_SYMBOL(scsi_cmd_get_serial);
int scsi_dispatch_cmd(struct scsi_cmnd *cmd)
{
struct Scsi_Host *host = cmd->device->host;
unsigned long timeout;
int rtn = 0;
atomic_inc(&cmd->device->iorequest_cnt);
......@@ -704,28 +698,6 @@ int scsi_dispatch_cmd(struct scsi_cmnd *cmd)
(cmd->device->lun << 5 & 0xe0);
}
/*
* We will wait MIN_RESET_DELAY clock ticks after the last reset so
* we can avoid the drive not being ready.
*/
timeout = host->last_reset + MIN_RESET_DELAY;
if (host->resetting && time_before(jiffies, timeout)) {
int ticks_remaining = timeout - jiffies;
/*
* NOTE: This may be executed from within an interrupt
* handler! This is bad, but for now, it'll do. The irq
* level of the interrupt handler has been masked out by the
* platform dependent interrupt handling code already, so the
* sti() here will not cause another call to the SCSI host's
* interrupt handler (assuming there is one irq-level per
* host).
*/
while (--ticks_remaining >= 0)
mdelay(1 + 999 / HZ);
host->resetting = 0;
}
scsi_log_send(cmd);
/*
......
......@@ -598,8 +598,6 @@ struct Scsi_Host {
unsigned int host_eh_scheduled; /* EH scheduled without command */
unsigned int host_no; /* Used for IOCTL_GET_IDLUN, /proc/scsi et al. */
int resetting; /* if set, it means that last_reset is a valid value */
unsigned long last_reset;
/*
* These three parameters can be used to allow for wide scsi,
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册