net: ftgmac100: move phy connect out from ftgmac100_setup_mdio

Split MDIO registration and PHY connect into ftgmac100_setup_mdio and
ftgmac100_mii_probe.
Signed-off-by: NIvan Mikhaylov <i.mikhaylov@yadro.com>
Reviewed-by: NAndrew Lunn <andrew@lunn.ch>
Signed-off-by: NJakub Kicinski <kuba@kernel.org>

drivers/net/ethernet/faraday/ftgmac100.c

@@ -1044,10 +1044,39 @@ static void ftgmac100_adjust_link(struct net_device *netdev)
 	schedule_work(&priv->reset_task);
 }
 
-static int ftgmac100_mii_probe(struct ftgmac100 *priv, phy_interface_t intf)
+static int ftgmac100_mii_probe(struct net_device *netdev)
 {
-	struct net_device *netdev = priv->netdev;
+	struct ftgmac100 *priv = netdev_priv(netdev);
+	struct platform_device *pdev = to_platform_device(priv->dev);
+	struct device_node *np = pdev->dev.of_node;
 	struct phy_device *phydev;
+	phy_interface_t phy_intf;
+	int err;
+
+	/* Default to RGMII. It's a gigabit part after all */
+	err = of_get_phy_mode(np, &phy_intf);
+	if (err)
+		phy_intf = PHY_INTERFACE_MODE_RGMII;
+
+	/* Aspeed only supports these. I don't know about other IP
+	 * block vendors so I'm going to just let them through for
+	 * now. Note that this is only a warning if for some obscure
+	 * reason the DT really means to lie about it or it's a newer
+	 * part we don't know about.
+	 *
+	 * On the Aspeed SoC there are additionally straps and SCU
+	 * control bits that could tell us what the interface is
+	 * (or allow us to configure it while the IP block is held
+	 * in reset). For now I chose to keep this driver away from
+	 * those SoC specific bits and assume the device-tree is
+	 * right and the SCU has been configured properly by pinmux
+	 * or the firmware.
+	 */
+	if (priv->is_aspeed && !(phy_interface_mode_is_rgmii(phy_intf))) {
+		netdev_warn(netdev,
+			    "Unsupported PHY mode %s !\n",
+			    phy_modes(phy_intf));
+	}
 
 	phydev = phy_find_first(priv->mii_bus);
 	if (!phydev) {
@@ -1056,7 +1085,7 @@ static int ftgmac100_mii_probe(struct ftgmac100 *priv, phy_interface_t intf)
 	}
 
 	phydev = phy_connect(netdev, phydev_name(phydev),
-			     &ftgmac100_adjust_link, intf);
+			     &ftgmac100_adjust_link, phy_intf);
 
 	if (IS_ERR(phydev)) {
 		netdev_err(netdev, "%s: Could not attach to PHY\n", netdev->name);
@@ -1601,7 +1630,6 @@ static int ftgmac100_setup_mdio(struct net_device *netdev)
 {
 	struct ftgmac100 *priv = netdev_priv(netdev);
 	struct platform_device *pdev = to_platform_device(priv->dev);
-	phy_interface_t phy_intf = PHY_INTERFACE_MODE_RGMII;
 	struct device_node *np = pdev->dev.of_node;
 	int i, err = 0;
 	u32 reg;
@@ -1623,39 +1651,6 @@ static int ftgmac100_setup_mdio(struct net_device *netdev)
 		iowrite32(reg, priv->base + FTGMAC100_OFFSET_REVR);
 	}
 
-	/* Get PHY mode from device-tree */
-	if (np) {
-		/* Default to RGMII. It's a gigabit part after all */
-		err = of_get_phy_mode(np, &phy_intf);
-		if (err)
-			phy_intf = PHY_INTERFACE_MODE_RGMII;
-
-		/* Aspeed only supports these. I don't know about other IP
-		 * block vendors so I'm going to just let them through for
-		 * now. Note that this is only a warning if for some obscure
-		 * reason the DT really means to lie about it or it's a newer
-		 * part we don't know about.
-		 *
-		 * On the Aspeed SoC there are additionally straps and SCU
-		 * control bits that could tell us what the interface is
-		 * (or allow us to configure it while the IP block is held
-		 * in reset). For now I chose to keep this driver away from
-		 * those SoC specific bits and assume the device-tree is
-		 * right and the SCU has been configured properly by pinmux
-		 * or the firmware.
-		 */
-		if (priv->is_aspeed &&
-		    phy_intf != PHY_INTERFACE_MODE_RMII &&
-		    phy_intf != PHY_INTERFACE_MODE_RGMII &&
-		    phy_intf != PHY_INTERFACE_MODE_RGMII_ID &&
-		    phy_intf != PHY_INTERFACE_MODE_RGMII_RXID &&
-		    phy_intf != PHY_INTERFACE_MODE_RGMII_TXID) {
-			netdev_warn(netdev,
-				   "Unsupported PHY mode %s !\n",
-				   phy_modes(phy_intf));
-		}
-	}
-
 	priv->mii_bus->name = "ftgmac100_mdio";
 	snprintf(priv->mii_bus->id, MII_BUS_ID_SIZE, "%s-%d",
 		 pdev->name, pdev->id);
@@ -1673,29 +1668,28 @@ static int ftgmac100_setup_mdio(struct net_device *netdev)
 		goto err_register_mdiobus;
 	}
 
-	err = ftgmac100_mii_probe(priv, phy_intf);
-	if (err) {
-		dev_err(priv->dev, "MII Probe failed!\n");
-		goto err_mii_probe;
-	}
-
 	return 0;
 
-err_mii_probe:
-	mdiobus_unregister(priv->mii_bus);
 err_register_mdiobus:
 	mdiobus_free(priv->mii_bus);
 	return err;
 }
 
+static void ftgmac100_phy_disconnect(struct net_device *netdev)
+{
+	if (!netdev->phydev)
+		return;
+
+	phy_disconnect(netdev->phydev);
+}
+
 static void ftgmac100_destroy_mdio(struct net_device *netdev)
 {
 	struct ftgmac100 *priv = netdev_priv(netdev);
 
-	if (!netdev->phydev)
+	if (!priv->mii_bus)
 		return;
 
-	phy_disconnect(netdev->phydev);
 	mdiobus_unregister(priv->mii_bus);
 	mdiobus_free(priv->mii_bus);
 }
@@ -1830,14 +1824,14 @@ static int ftgmac100_probe(struct platform_device *pdev)
 	if (np && of_get_property(np, "use-ncsi", NULL)) {
 		if (!IS_ENABLED(CONFIG_NET_NCSI)) {
 			dev_err(&pdev->dev, "NCSI stack not enabled\n");
-			goto err_ncsi_dev;
+			goto err_phy_connect;
 		}
 
 		dev_info(&pdev->dev, "Using NCSI interface\n");
 		priv->use_ncsi = true;
 		priv->ndev = ncsi_register_dev(netdev, ftgmac100_ncsi_handler);
 		if (!priv->ndev)
-			goto err_ncsi_dev;
+			goto err_phy_connect;
 	} else if (np && of_get_property(np, "phy-handle", NULL)) {
 		struct phy_device *phy;
 
@@ -1865,12 +1859,19 @@ static int ftgmac100_probe(struct platform_device *pdev)
 		err = ftgmac100_setup_mdio(netdev);
 		if (err)
 			goto err_setup_mdio;
+
+		err = ftgmac100_mii_probe(netdev);
+		if (err) {
+			dev_err(priv->dev, "MII probe failed!\n");
+			goto err_ncsi_dev;
+		}
+
 	}
 
 	if (priv->is_aspeed) {
 		err = ftgmac100_setup_clk(priv);
 		if (err)
-			goto err_ncsi_dev;
+			goto err_phy_connect;
 	}
 
 	/* Default ring sizes */
@@ -1906,6 +1907,8 @@ static int ftgmac100_probe(struct platform_device *pdev)
 err_register_netdev:
 	clk_disable_unprepare(priv->rclk);
 	clk_disable_unprepare(priv->clk);
+err_phy_connect:
+	ftgmac100_phy_disconnect(netdev);
 err_ncsi_dev:
 	ftgmac100_destroy_mdio(netdev);
 err_setup_mdio:
@@ -1936,6 +1939,7 @@ static int ftgmac100_remove(struct platform_device *pdev)
 	 */
 	cancel_work_sync(&priv->reset_task);
 
+	ftgmac100_phy_disconnect(netdev);
 	ftgmac100_destroy_mdio(netdev);
 
 	iounmap(priv->base);