staging/rdma/hfi1: Always download SBus firmware

B0 dual port parts require the SBus firmware to always be
downloaded.

Remove reset of the SBus Master spico.  It is not necessary
since the SBus firmware download already does that.
Reviewed-by: NDennis Dalessandro <dennis.dalessandro@intel.com>
Signed-off-by: NDean Luick <dean.luick@intel.com>
Signed-off-by: NJubin John <jubin.john@intel.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/staging/rdma/hfi1/firmware.c

@@ -1568,7 +1568,7 @@ int load_pcie_firmware(struct hfi1_devdata *dd)
 	/* both firmware loads below use the SBus */
 	set_sbus_fast_mode(dd);
 
-	if (fw_sbus_load && (dd->flags & HFI1_DO_INIT_ASIC)) {
+	if (fw_sbus_load) {
 		turn_off_spicos(dd, SPICO_SBUS);
 		ret = load_sbus_firmware(dd, &fw_sbus);
 		if (ret)

drivers/staging/rdma/hfi1/pcie.c

@@ -949,17 +949,7 @@ int do_pcie_gen3_transition(struct hfi1_devdata *dd)
 	}
 
 retry:
-
-	if (therm) {
-		/*
-		 * toggle SPICO_ENABLE to get back to the state
-		 * just after the firmware load
-		 */
-		sbus_request(dd, SBUS_MASTER_BROADCAST, 0x01,
-			WRITE_SBUS_RECEIVER, 0x00000040);
-		sbus_request(dd, SBUS_MASTER_BROADCAST, 0x01,
-			WRITE_SBUS_RECEIVER, 0x00000140);
-	}
+	/* the SBus download will reset the spico for thermal */
 
 	/* step 3: download SBus Master firmware */
 	/* step 4: download PCIe Gen3 SerDes firmware */