arm64: boot protocol documentation update for GICv3

Linux has some requirements that must be satisfied in order to boot
on a system built with a GICv3.
Acked-by: NChristoffer Dall <christoffer.dall@linaro.org>
Signed-off-by: NMarc Zyngier <marc.zyngier@arm.com>

Documentation/arm64/booting.txt

@@ -141,6 +141,14 @@ Before jumping into the kernel, the following conditions must be met:
   the kernel image will be entered must be initialised by software at a
   higher exception level to prevent execution in an UNKNOWN state.
 
+  For systems with a GICv3 interrupt controller:
+  - If EL3 is present:
+    ICC_SRE_EL3.Enable (bit 3) must be initialiased to 0b1.
+    ICC_SRE_EL3.SRE (bit 0) must be initialised to 0b1.
+  - If the kernel is entered at EL1:
+    ICC.SRE_EL2.Enable (bit 3) must be initialised to 0b1
+    ICC_SRE_EL2.SRE (bit 0) must be initialised to 0b1.
+
 The requirements described above for CPU mode, caches, MMUs, architected
 timers, coherency and system registers apply to all CPUs.  All CPUs must
 enter the kernel in the same exception level.