提交 62b0e924 编写于 作者: I Ido Schimmel 提交者: David S. Miller

mlxsw: reg: Add high and low temperature thresholds

The ASIC has the ability to generate events whenever a sensor indicates
the temperature goes above or below its high or low thresholds,
respectively.

In new firmware versions the firmware enforces a minimum of 5
degrees Celsius difference between both thresholds. Make the driver
conform to this requirement.

Note that this is required even when the events are disabled, as in
certain systems interrupts are generated via GPIO based on these
thresholds.

Fixes: 85926f87 ("mlxsw: reg: Add definition of temperature management registers")
Signed-off-by: NIdo Schimmel <idosch@mellanox.com>
Signed-off-by: NJiri Pirko <jiri@mellanox.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 1cf098b7
......@@ -5827,6 +5827,29 @@ MLXSW_ITEM32(reg, mtmp, mtr, 0x08, 30, 1);
*/
MLXSW_ITEM32(reg, mtmp, max_temperature, 0x08, 0, 16);
/* reg_mtmp_tee
* Temperature Event Enable.
* 0 - Do not generate event
* 1 - Generate event
* 2 - Generate single event
* Access: RW
*/
MLXSW_ITEM32(reg, mtmp, tee, 0x0C, 30, 2);
#define MLXSW_REG_MTMP_THRESH_HI 0x348 /* 105 Celsius */
/* reg_mtmp_temperature_threshold_hi
* High threshold for Temperature Warning Event. In 0.125 Celsius.
* Access: RW
*/
MLXSW_ITEM32(reg, mtmp, temperature_threshold_hi, 0x0C, 0, 16);
/* reg_mtmp_temperature_threshold_lo
* Low threshold for Temperature Warning Event. In 0.125 Celsius.
* Access: RW
*/
MLXSW_ITEM32(reg, mtmp, temperature_threshold_lo, 0x10, 0, 16);
#define MLXSW_REG_MTMP_SENSOR_NAME_SIZE 8
/* reg_mtmp_sensor_name
......@@ -5843,6 +5866,8 @@ static inline void mlxsw_reg_mtmp_pack(char *payload, u8 sensor_index,
mlxsw_reg_mtmp_sensor_index_set(payload, sensor_index);
mlxsw_reg_mtmp_mte_set(payload, max_temp_enable);
mlxsw_reg_mtmp_mtr_set(payload, max_temp_reset);
mlxsw_reg_mtmp_temperature_threshold_hi_set(payload,
MLXSW_REG_MTMP_THRESH_HI);
}
static inline void mlxsw_reg_mtmp_unpack(char *payload, unsigned int *p_temp,
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册