serial: samsung: enable clock before clearing pending interrupts during init

Ensure that the uart controller clock is enabled prior to writing to the
interrupt mask and pending registers in the s3c24xx_serial_init_port
function.
Signed-off-by: NChander Kashyap <chander.kashyap@linaro.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/samsung.c

@@ -1166,6 +1166,18 @@ static int s3c24xx_serial_init_port(struct s3c24xx_uart_port *ourport,
 		ourport->tx_irq = ret;
 
 	ourport->clk	= clk_get(&platdev->dev, "uart");
+	if (IS_ERR(ourport->clk)) {
+		pr_err("%s: Controller clock not found\n",
+				dev_name(&platdev->dev));
+		return PTR_ERR(ourport->clk);
+	}
+
+	ret = clk_prepare_enable(ourport->clk);
+	if (ret) {
+		pr_err("uart: clock failed to prepare+enable: %d\n", ret);
+		clk_put(ourport->clk);
+		return ret;
+	}
 
 	/* Keep all interrupts masked and cleared */
 	if (s3c24xx_serial_has_interrupt_mask(port)) {
@@ -1180,6 +1192,7 @@ static int s3c24xx_serial_init_port(struct s3c24xx_uart_port *ourport,
 
 	/* reset the fifos (and setup the uart) */
 	s3c24xx_serial_resetport(port, cfg);
+	clk_disable_unprepare(ourport->clk);
 	return 0;
 }