net: dsa: qca8k: make sure PAD0 MAC06 exchange is disabled

Some device set MAC06 exchange in the bootloader. This cause some
problem as we don't support this strange mode and we just set the port6
as the primary CPU port. With MAC06 exchange, PAD0 reg configure port6
instead of port0. Add an extra check and explicitly disable MAC06 exchange
to correctly configure the port PAD config.
Signed-off-by: NAnsuel Smith <ansuelsmth@gmail.com>
Fixes: 3fcf734a ("net: dsa: qca8k: add support for cpu port 6")
Reviewed-by: NVladimir Oltean <olteanv@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/dsa/qca8k.c

@@ -1109,6 +1109,14 @@ qca8k_setup(struct dsa_switch *ds)
 	if (ret)
 		return ret;
 
+	/* Make sure MAC06 is disabled */
+	ret = qca8k_reg_clear(priv, QCA8K_REG_PORT0_PAD_CTRL,
+			      QCA8K_PORT0_PAD_MAC06_EXCHANGE_EN);
+	if (ret) {
+		dev_err(priv->dev, "failed disabling MAC06 exchange");
+		return ret;
+	}
+
 	/* Enable CPU Port */
 	ret = qca8k_reg_set(priv, QCA8K_REG_GLOBAL_FW_CTRL0,
 			    QCA8K_GLOBAL_FW_CTRL0_CPU_PORT_EN);

drivers/net/dsa/qca8k.h

@@ -34,6 +34,7 @@
 #define   QCA8K_MASK_CTRL_DEVICE_ID_MASK		GENMASK(15, 8)
 #define   QCA8K_MASK_CTRL_DEVICE_ID(x)			((x) >> 8)
 #define QCA8K_REG_PORT0_PAD_CTRL			0x004
+#define   QCA8K_PORT0_PAD_MAC06_EXCHANGE_EN		BIT(31)
 #define   QCA8K_PORT0_PAD_SGMII_RXCLK_FALLING_EDGE	BIT(19)
 #define   QCA8K_PORT0_PAD_SGMII_TXCLK_FALLING_EDGE	BIT(18)
 #define QCA8K_REG_PORT5_PAD_CTRL			0x008