提交 5eff0edf 编写于 作者: M Maarten Lankhorst

drm/i915: Convert intel_dsi to use atomic state

Signed-off-by: NMaarten Lankhorst <maarten.lankhorst@linux.intel.com>
Link: http://patchwork.freedesktop.org/patch/msgid/1470755054-32699-11-git-send-email-maarten.lankhorst@linux.intel.com
[mlankhorst: Unbreak bxt_dsi_get_pipe_config]
Reviewed-by: NDaniel Vetter <daniel.vetter@ffwll.ch>
上级 ae9a911b
......@@ -534,16 +534,15 @@ static void intel_dsi_enable(struct intel_encoder *encoder)
intel_panel_enable_backlight(intel_dsi->attached_connector);
}
static void intel_dsi_prepare(struct intel_encoder *intel_encoder);
static void intel_dsi_prepare(struct intel_encoder *intel_encoder,
struct intel_crtc_state *pipe_config);
static void intel_dsi_pre_enable(struct intel_encoder *encoder,
struct intel_crtc_state *pipe_config,
struct drm_connector_state *conn_state)
{
struct drm_device *dev = encoder->base.dev;
struct drm_i915_private *dev_priv = to_i915(dev);
struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
struct intel_dsi *intel_dsi = enc_to_intel_dsi(&encoder->base);
struct intel_crtc *crtc = to_intel_crtc(encoder->base.crtc);
enum port port;
DRM_DEBUG_KMS("\n");
......@@ -553,9 +552,9 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder,
* lock. It needs to be fully powered down to fix it.
*/
intel_disable_dsi_pll(encoder);
intel_enable_dsi_pll(encoder, crtc->config);
intel_enable_dsi_pll(encoder, pipe_config);
intel_dsi_prepare(encoder);
intel_dsi_prepare(encoder, pipe_config);
/* Panel Enable over CRC PMIC */
if (intel_dsi->gpio_panel)
......@@ -828,6 +827,7 @@ static void bxt_dsi_get_pipe_config(struct intel_encoder *encoder,
u16 crtc_htotal_sw, crtc_hsync_start_sw, crtc_hsync_end_sw,
crtc_hblank_start_sw, crtc_hblank_end_sw;
/* FIXME: hw readout should not depend on SW state */
intel_crtc = to_intel_crtc(encoder->base.crtc);
adjusted_mode_sw = &intel_crtc->config->base.adjusted_mode;
......@@ -1113,14 +1113,15 @@ static u32 pixel_format_to_reg(enum mipi_dsi_pixel_format fmt)
}
}
static void intel_dsi_prepare(struct intel_encoder *intel_encoder)
static void intel_dsi_prepare(struct intel_encoder *intel_encoder,
struct intel_crtc_state *pipe_config)
{
struct drm_encoder *encoder = &intel_encoder->base;
struct drm_device *dev = encoder->dev;
struct drm_i915_private *dev_priv = to_i915(dev);
struct intel_crtc *intel_crtc = to_intel_crtc(encoder->crtc);
struct intel_crtc *intel_crtc = to_intel_crtc(pipe_config->base.crtc);
struct intel_dsi *intel_dsi = enc_to_intel_dsi(encoder);
const struct drm_display_mode *adjusted_mode = &intel_crtc->config->base.adjusted_mode;
const struct drm_display_mode *adjusted_mode = &pipe_config->base.adjusted_mode;
enum port port;
unsigned int bpp = mipi_dsi_pixel_format_to_bpp(intel_dsi->pixel_format);
u32 val, tmp;
......@@ -1357,7 +1358,7 @@ static int intel_dsi_set_property(struct drm_connector *connector,
intel_connector->panel.fitting_mode = val;
}
crtc = intel_attached_encoder(connector)->base.crtc;
crtc = connector->state->crtc;
if (crtc && crtc->state->enable) {
/*
* If the CRTC is enabled, the display will be changed
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册