提交 5e46631b 编写于 作者: H Hannes Reinecke 提交者: James Bottomley

[SCSI] aic7xxx/aic79xx: New device ids

Signed-off-by: NJames Bottomley <James.Bottomley@SteelEye.com>
上级 bcc1e382
......@@ -38,9 +38,7 @@
* IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGES.
*
* $Id: //depot/aic7xxx/aic7xxx/aic79xx_pci.c#77 $
*
* $FreeBSD$
* $Id: //depot/aic7xxx/aic7xxx/aic79xx_pci.c#89 $
*/
#ifdef __linux__
......@@ -114,6 +112,13 @@ struct ahd_pci_identity ahd_pci_ident_table [] =
"Adaptec 29320ALP Ultra320 SCSI adapter",
ahd_aic7901_setup
},
/* aic7901A based controllers */
{
ID_AHA_29320LP,
ID_ALL_MASK,
"Adaptec 29320LP Ultra320 SCSI adapter",
ahd_aic7901A_setup
},
/* aic7902 based controllers */
{
ID_AHA_29320,
......@@ -127,12 +132,6 @@ struct ahd_pci_identity ahd_pci_ident_table [] =
"Adaptec 29320B Ultra320 SCSI adapter",
ahd_aic7902_setup
},
{
ID_AHA_29320LP,
ID_ALL_MASK,
"Adaptec 29320LP Ultra320 SCSI adapter",
ahd_aic7901A_setup
},
{
ID_AHA_39320,
ID_ALL_MASK,
......@@ -145,6 +144,12 @@ struct ahd_pci_identity ahd_pci_ident_table [] =
"Adaptec 39320 Ultra320 SCSI adapter",
ahd_aic7902_setup
},
{
ID_AHA_39320_B_DELL,
ID_ALL_MASK,
"Adaptec (Dell OEM) 39320 Ultra320 SCSI adapter",
ahd_aic7902_setup
},
{
ID_AHA_39320A,
ID_ALL_MASK,
......@@ -668,6 +673,7 @@ ahd_configure_termination(struct ahd_softc *ahd, u_int adapter_control)
* Now set the termination based on what we found.
*/
sxfrctl1 = ahd_inb(ahd, SXFRCTL1) & ~STPWEN;
ahd->flags &= ~AHD_TERM_ENB_A;
if ((termctl & FLX_TERMCTL_ENPRILOW) != 0) {
ahd->flags |= AHD_TERM_ENB_A;
sxfrctl1 |= STPWEN;
......
......@@ -53,14 +53,15 @@
#define ID_AHA_29320ALP 0x8017900500449005ull
#define ID_AIC7901A 0x801E9005FFFF9005ull
#define ID_AHA_29320 0x8012900500429005ull
#define ID_AHA_29320B 0x8013900500439005ull
#define ID_AHA_29320LP 0x8014900500449005ull
#define ID_AIC7902 0x801F9005FFFF9005ull
#define ID_AIC7902_B 0x801D9005FFFF9005ull
#define ID_AHA_39320 0x8010900500409005ull
#define ID_AHA_29320 0x8012900500429005ull
#define ID_AHA_29320B 0x8013900500439005ull
#define ID_AHA_39320_B 0x8015900500409005ull
#define ID_AHA_39320_B_DELL 0x8015900501681028ull
#define ID_AHA_39320A 0x8016900500409005ull
#define ID_AHA_39320D 0x8011900500419005ull
#define ID_AHA_39320D_B 0x801C900500419005ull
......
......@@ -39,9 +39,7 @@
* IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGES.
*
* $Id: //depot/aic7xxx/aic7xxx/aic7xxx_pci.c#69 $
*
* $FreeBSD$
* $Id: //depot/aic7xxx/aic7xxx/aic7xxx_pci.c#79 $
*/
#ifdef __linux__
......@@ -393,6 +391,12 @@ struct ahc_pci_identity ahc_pci_ident_table [] =
"Adaptec aic7892 Ultra160 SCSI adapter (ARO)",
ahc_aic7892_setup
},
{
ID_AHA_2915_30LP,
ID_ALL_MASK,
"Adaptec 2915/30LP Ultra160 SCSI adapter",
ahc_aic7892_setup
},
/* aic7895 based controllers */
{
ID_AHA_2940U_DUAL,
......@@ -1193,9 +1197,19 @@ ahc_pci_test_register_access(struct ahc_softc *ahc)
* use for this test.
*/
hcntrl = ahc_inb(ahc, HCNTRL);
if (hcntrl == 0xFF)
goto fail;
if ((hcntrl & CHIPRST) != 0) {
/*
* The chip has not been initialized since
* PCI/EISA/VLB bus reset. Don't trust
* "left over BIOS data".
*/
ahc->flags |= AHC_NO_BIOS_INIT;
}
/*
* Next create a situation where write combining
* or read prefetching could be initiated by the
......@@ -1307,6 +1321,10 @@ check_extport(struct ahc_softc *ahc, u_int *sxfrctl1)
sd.sd_chip = C56_66;
}
ahc_release_seeprom(&sd);
/* Remember the SEEPROM type for later */
if (sd.sd_chip == C56_66)
ahc->flags |= AHC_LARGE_SEEPROM;
}
if (!have_seeprom) {
......
......@@ -105,6 +105,7 @@
#define ID_AHA_29160C 0x0080900562209005ull
#define ID_AHA_29160B 0x00809005E2209005ull
#define ID_AHA_19160B 0x0081900562A19005ull
#define ID_AHA_2915_30LP 0x0082900502109005ull
#define ID_AIC7896 0x005F9005FFFF9005ull
#define ID_AIC7896_ARO 0x00539005FFFF9005ull
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册