ARM: netx: stop using mach/timex.h

mach/timex.h is the last remaining header that is unused for multiarch
builds but necessary for singlearch builds. To allow to get rid of it
for singlearch builds, too, drop its usage in netx arch code by
substituting CLOCK_TICK_RATE and LATCH by a local cpp symbol.
Acked-by: NSascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: NUwe Kleine-König <u.kleine-koenig@pengutronix.de>

arch/arm/mach-netx/time.c

@@ -28,6 +28,9 @@
 #include <asm/mach/time.h>
 #include <mach/netx-regs.h>
 
+#define NETX_CLOCK_FREQ 100000000
+#define NETX_LATCH DIV_ROUND_CLOSEST(NETX_CLOCK_FREQ, HZ)
+
 #define TIMER_CLOCKEVENT 0
 #define TIMER_CLOCKSOURCE 1
 
@@ -41,7 +44,7 @@ static void netx_set_mode(enum clock_event_mode mode,
 
 	switch (mode) {
 	case CLOCK_EVT_MODE_PERIODIC:
-		writel(LATCH, NETX_GPIO_COUNTER_MAX(TIMER_CLOCKEVENT));
+		writel(NETX_LATCH, NETX_GPIO_COUNTER_MAX(TIMER_CLOCKEVENT));
 		tmode = NETX_GPIO_COUNTER_CTRL_RST_EN |
 			NETX_GPIO_COUNTER_CTRL_IRQ_EN |
 			NETX_GPIO_COUNTER_CTRL_RUN;
@@ -114,7 +117,7 @@ void __init netx_timer_init(void)
 	/* Reset the timer value to zero */
 	writel(0, NETX_GPIO_COUNTER_CURRENT(0));
 
-	writel(LATCH, NETX_GPIO_COUNTER_MAX(0));
+	writel(NETX_LATCH, NETX_GPIO_COUNTER_MAX(0));
 
 	/* acknowledge interrupt */
 	writel(COUNTER_BIT(0), NETX_GPIO_IRQ);
@@ -137,11 +140,11 @@ void __init netx_timer_init(void)
 			NETX_GPIO_COUNTER_CTRL(TIMER_CLOCKSOURCE));
 
 	clocksource_mmio_init(NETX_GPIO_COUNTER_CURRENT(TIMER_CLOCKSOURCE),
-		"netx_timer", CLOCK_TICK_RATE, 200, 32, clocksource_mmio_readl_up);
+		"netx_timer", NETX_CLOCK_FREQ, 200, 32, clocksource_mmio_readl_up);
 
 	/* with max_delta_ns >= delta2ns(0x800) the system currently runs fine.
 	 * Adding some safety ... */
 	netx_clockevent.cpumask = cpumask_of(0);
-	clockevents_config_and_register(&netx_clockevent, CLOCK_TICK_RATE,
+	clockevents_config_and_register(&netx_clockevent, NETX_CLOCK_FREQ,
 					0xa00, 0xfffffffe);
 }