net: macb: Restart tx only if queue pointer is lagging

commit 42983885 ("net: macb: restart tx after tx used bit read")
added support for restarting transmission. Restarting tx does not work
in case controller asserts TXUBR interrupt and TQBP is already at the end
of the tx queue. In that situation, restarting tx will immediately cause
assertion of another TXUBR interrupt. The driver will end up in an infinite
interrupt loop which it cannot break out of.

For cases where TQBP is at the end of the tx queue, instead
only clear TX_USED interrupt. As more data gets pushed to the queue,
transmission will resume.

This issue was observed on a Xilinx Zynq-7000 based board.
During stress test of the network interface,
driver would get stuck on interrupt loop within seconds or minutes
causing CPU to stall.
Signed-off-by: NTomas Melin <tomas.melin@vaisala.com>
Tested-by: NClaudiu Beznea <claudiu.beznea@microchip.com>
Reviewed-by: NClaudiu Beznea <claudiu.beznea@microchip.com>
Link: https://lore.kernel.org/r/20220407161659.14532-1-tomas.melin@vaisala.comSigned-off-by: NJakub Kicinski <kuba@kernel.org>

drivers/net/ethernet/cadence/macb_main.c

@@ -1658,6 +1658,7 @@ static void macb_tx_restart(struct macb_queue *queue)
 	unsigned int head = queue->tx_head;
 	unsigned int tail = queue->tx_tail;
 	struct macb *bp = queue->bp;
+	unsigned int head_idx, tbqp;
 
 	if (bp->caps & MACB_CAPS_ISR_CLEAR_ON_WRITE)
 		queue_writel(queue, ISR, MACB_BIT(TXUBR));
@@ -1665,6 +1666,13 @@ static void macb_tx_restart(struct macb_queue *queue)
 	if (head == tail)
 		return;
 
+	tbqp = queue_readl(queue, TBQP) / macb_dma_desc_get_size(bp);
+	tbqp = macb_adj_dma_desc_idx(bp, macb_tx_ring_wrap(bp, tbqp));
+	head_idx = macb_adj_dma_desc_idx(bp, macb_tx_ring_wrap(bp, head));
+
+	if (tbqp == head_idx)
+		return;
+
 	macb_writel(bp, NCR, macb_readl(bp, NCR) | MACB_BIT(TSTART));
 }