Btrfs: replace: cache rbio when rebuild data on missing device

Rebuild on missing device is as same as recover, after it's done, rbio
has data which is consistent with on-disk data, so it can be cached to
avoid further reads.
Signed-off-by: NLiu Bo <bo.li.liu@oracle.com>
Signed-off-by: NLiu Bo <bo.liu@linux.alibaba.com>
Signed-off-by: NDavid Sterba <dsterba@suse.com>

fs/btrfs/raid56.c

@@ -1987,7 +1987,13 @@ static void __raid_recover_end_io(struct btrfs_raid_bio *rbio)
 	kfree(pointers);
 
 cleanup_io:
-	if (rbio->operation == BTRFS_RBIO_READ_REBUILD) {
+	/*
+	 * Similar to READ_REBUILD, REBUILD_MISSING at this point also has a
+	 * valid rbio which is consistent with ondisk content, thus such a
+	 * valid rbio can be cached to avoid further disk reads.
+	 */
+	if (rbio->operation == BTRFS_RBIO_READ_REBUILD ||
+	    rbio->operation == BTRFS_RBIO_REBUILD_MISSING) {
 		/*
 		 * - In case of two failures, where rbio->failb != -1:
 		 *
@@ -2008,8 +2014,6 @@ static void __raid_recover_end_io(struct btrfs_raid_bio *rbio)
 		else
 			clear_bit(RBIO_CACHE_READY_BIT, &rbio->flags);
 
-		rbio_orig_end_io(rbio, err);
-	} else if (rbio->operation == BTRFS_RBIO_REBUILD_MISSING) {
 		rbio_orig_end_io(rbio, err);
 	} else if (err == BLK_STS_OK) {
 		rbio->faila = -1;