ath: Use safer key clearing with key cache entries

It is possible for there to be pending frames in TXQs with a reference
to the key cache entry that is being deleted. If such a key cache entry
is cleared, those pending frame in TXQ might get transmitted without
proper encryption. It is safer to leave the previously used key into the
key cache in such cases. Instead, only clear the MAC address to prevent
RX processing from using this key cache entry.

This is needed in particularly in AP mode where the TXQs cannot be
flushed on station disconnection. This change alone may not be able to
address all cases where the key cache entry might get reused for other
purposes immediately (the key cache entry should be released for reuse
only once the TXQs do not have any remaining references to them), but
this makes it less likely to get unprotected frames and the more
complete changes may end up being significantly more complex.
Signed-off-by: NJouni Malinen <jouni@codeaurora.org>
Signed-off-by: NKalle Valo <kvalo@codeaurora.org>
Link: https://lore.kernel.org/r/20201214172118.18100-2-jouni@codeaurora.org

drivers/net/wireless/ath/key.c

@@ -583,7 +583,16 @@ EXPORT_SYMBOL(ath_key_config);
  */
 void ath_key_delete(struct ath_common *common, struct ieee80211_key_conf *key)
 {
-	ath_hw_keyreset(common, key->hw_key_idx);
+	/* Leave CCMP and TKIP (main key) configured to avoid disabling
+	 * encryption for potentially pending frames already in a TXQ with the
+	 * keyix pointing to this key entry. Instead, only clear the MAC address
+	 * to prevent RX processing from using this key cache entry.
+	 */
+	if (test_bit(key->hw_key_idx, common->ccmp_keymap) ||
+	    test_bit(key->hw_key_idx, common->tkip_keymap))
+		ath_hw_keysetmac(common, key->hw_key_idx, NULL);
+	else
+		ath_hw_keyreset(common, key->hw_key_idx);
 	if (key->hw_key_idx < IEEE80211_WEP_NKID)
 		return;