i2c: rcar: use the new get_bus_free callback

To break out of recovery as early as possible, feed back the bus_free
logic state.
Signed-off-by: NWolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: NWolfram Sang <wsa@the-dreams.de>

drivers/i2c/busses/i2c-rcar.c

@@ -179,8 +179,6 @@ static void rcar_i2c_set_scl(struct i2c_adapter *adap, int val)
 	rcar_i2c_write(priv, ICMCR, priv->recovery_icmcr);
 };
 
-/* No get_sda, because the HW only reports its bus free logic, not SDA itself */
-
 static void rcar_i2c_set_sda(struct i2c_adapter *adap, int val)
 {
 	struct rcar_i2c_priv *priv = i2c_get_adapdata(adap);
@@ -193,10 +191,19 @@ static void rcar_i2c_set_sda(struct i2c_adapter *adap, int val)
 	rcar_i2c_write(priv, ICMCR, priv->recovery_icmcr);
 };
 
+static int rcar_i2c_get_bus_free(struct i2c_adapter *adap)
+{
+	struct rcar_i2c_priv *priv = i2c_get_adapdata(adap);
+
+	return !(rcar_i2c_read(priv, ICMCR) & FSDA);
+
+};
+
 static struct i2c_bus_recovery_info rcar_i2c_bri = {
 	.get_scl = rcar_i2c_get_scl,
 	.set_scl = rcar_i2c_set_scl,
 	.set_sda = rcar_i2c_set_sda,
+	.get_bus_free = rcar_i2c_get_bus_free,
 	.recover_bus = i2c_generic_scl_recovery,
 };
 static void rcar_i2c_init(struct rcar_i2c_priv *priv)
@@ -211,7 +218,7 @@ static void rcar_i2c_init(struct rcar_i2c_priv *priv)
 
 static int rcar_i2c_bus_barrier(struct rcar_i2c_priv *priv)
 {
-	int i, ret;
+	int i;
 
 	for (i = 0; i < LOOP_TIMEOUT; i++) {
 		/* make sure that bus is not busy */
@@ -222,13 +229,7 @@ static int rcar_i2c_bus_barrier(struct rcar_i2c_priv *priv)
 
 	/* Waiting did not help, try to recover */
 	priv->recovery_icmcr = MDBS | OBPC | FSDA | FSCL;
-	ret = i2c_recover_bus(&priv->adap);
-
-	/* No failure when recovering, so check bus busy bit again */
-	if (ret == 0)
-		ret = (rcar_i2c_read(priv, ICMCR) & FSDA) ? -EBUSY : 0;
-
-	return ret;
+	return i2c_recover_bus(&priv->adap);
 }
 
 static int rcar_i2c_clock_calculate(struct rcar_i2c_priv *priv, struct i2c_timings *t)