mmc: sdhci-iproc: Add ACPI bindings for the RPi

The RPi4 has an Arasan controller it carries over from the RPi3 and a newer
eMMC2 controller.  Because of a couple of quirks, it seems wiser to bind
these controllers to the same driver that DT is using on this platform
rather than the generic sdhci_acpi driver with PNP0D40.

So, BCM2847 describes the older Arasan and BRCME88C describes the newer
eMMC2. The older Arasan is reusing an existing ACPI _HID used by other OSes
booting these tables on the RPi.

With this change, Linux is capable of utilizing the SD card slot, and the
Wi-Fi when booted with UEFI+ACPI on the RPi4.
Signed-off-by: NJeremy Linton <jeremy.linton@arm.com>
Acked-by: NFlorian Fainelli <f.fainelli@gmail.com>
Link: https://lore.kernel.org/r/20210120000406.1843400-2-jeremy.linton@arm.comSigned-off-by: NUlf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/sdhci-iproc.c

@@ -296,9 +296,27 @@ static const struct of_device_id sdhci_iproc_of_match[] = {
 MODULE_DEVICE_TABLE(of, sdhci_iproc_of_match);
 
 #ifdef CONFIG_ACPI
+/*
+ * This is a duplicate of bcm2835_(pltfrm_)data without caps quirks
+ * which are provided by the ACPI table.
+ */
+static const struct sdhci_pltfm_data sdhci_bcm_arasan_data = {
+	.quirks = SDHCI_QUIRK_BROKEN_CARD_DETECTION |
+		  SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK |
+		  SDHCI_QUIRK_NO_HISPD_BIT,
+	.quirks2 = SDHCI_QUIRK2_PRESET_VALUE_BROKEN,
+	.ops = &sdhci_iproc_32only_ops,
+};
+
+static const struct sdhci_iproc_data bcm_arasan_data = {
+	.pdata = &sdhci_bcm_arasan_data,
+};
+
 static const struct acpi_device_id sdhci_iproc_acpi_ids[] = {
 	{ .id = "BRCM5871", .driver_data = (kernel_ulong_t)&iproc_cygnus_data },
 	{ .id = "BRCM5872", .driver_data = (kernel_ulong_t)&iproc_data },
+	{ .id = "BCM2847",  .driver_data = (kernel_ulong_t)&bcm_arasan_data },
+	{ .id = "BRCME88C", .driver_data = (kernel_ulong_t)&bcm2711_data },
 	{ /* sentinel */ }
 };
 MODULE_DEVICE_TABLE(acpi, sdhci_iproc_acpi_ids);