powerpc/iommu: Allow bypass-only for DMA

POWER8 and newer support a bypass mode which maps all host memory to
PCI buses so an IOMMU table is not always required. However if we fail to
create such a table, the DMA setup fails and the kernel does not boot.

This skips the 32bit DMA setup check if the bypass is selected.
Signed-off-by: NAlexey Kardashevskiy <aik@ozlabs.ru>
Reviewed-by: NDavid Gibson <david@gibson.dropbear.id.au>
Signed-off-by: NMichael Ellerman <mpe@ellerman.id.au>
Link: https://lore.kernel.org/r/20190718051139.74787-3-aik@ozlabs.ru

arch/powerpc/kernel/dma-iommu.c

@@ -122,18 +122,17 @@ int dma_iommu_dma_supported(struct device *dev, u64 mask)
 {
 	struct iommu_table *tbl = get_iommu_table_base(dev);
 
-	if (!tbl) {
-		dev_info(dev, "Warning: IOMMU dma not supported: mask 0x%08llx"
-			", table unavailable\n", mask);
-		return 0;
-	}
-
 	if (dev_is_pci(dev) && dma_iommu_bypass_supported(dev, mask)) {
 		dev->archdata.iommu_bypass = true;
 		dev_dbg(dev, "iommu: 64-bit OK, using fixed ops\n");
 		return 1;
 	}
 
+	if (!tbl) {
+		dev_err(dev, "Warning: IOMMU dma not supported: mask 0x%08llx, table unavailable\n", mask);
+		return 0;
+	}
+
 	if (tbl->it_offset > (mask >> tbl->it_page_shift)) {
 		dev_info(dev, "Warning: IOMMU offset too big for device mask\n");
 		dev_info(dev, "mask: 0x%08llx, table offset: 0x%08lx\n",