serial: 8250_dw: Avoid pslverr on reading empty receiver fifo

With PSLVERR_RESP_EN parameter set to 1, the device generates an error
response when an attempt to read an empty RBR with FIFO enabled.

This happens when LCR writes are ignored when UART is busy.
dw8250_check_lcr() in retries to update LCR, invokes dw8250_force_idle()
to clear and reset FIFO and eventually reads UART_RX causing the error.

Avoid this by not reading RBR/UART_RX when no data is available.
Reviewed-by: NAndy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: NVAMSHI GAJJELA <vamshigajjela@google.com>
Link: https://lore.kernel.org/r/20220713131722.2316829-1-vamshigajjela@google.comSigned-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/8250/8250_dw.c

@@ -83,8 +83,21 @@ static inline int dw8250_modify_msr(struct uart_port *p, int offset, int value)
 static void dw8250_force_idle(struct uart_port *p)
 {
 	struct uart_8250_port *up = up_to_u8250p(p);
+	unsigned int lsr;
 
 	serial8250_clear_and_reinit_fifos(up);
+
+	/*
+	 * With PSLVERR_RESP_EN parameter set to 1, the device generates an
+	 * error response when an attempt to read an empty RBR with FIFO
+	 * enabled.
+	 */
+	if (up->fcr & UART_FCR_ENABLE_FIFO) {
+		lsr = p->serial_in(p, UART_LSR);
+		if (!(lsr & UART_LSR_DR))
+			return;
+	}
+
 	(void)p->serial_in(p, UART_RX);
 }