arm64: Use arm64_force_sig_info instead of force_sig_info

Using arm64_force_sig_info means that printing messages about unhandled
signals is dealt with for us, so use that in preference to force_sig_info
and remove any homebrew printing code.
Signed-off-by: NWill Deacon <will.deacon@arm.com>

arch/arm64/kernel/debug-monitors.c

@@ -33,6 +33,7 @@
 #include <asm/daifflags.h>
 #include <asm/debug-monitors.h>
 #include <asm/system_misc.h>
+#include <asm/traps.h>
 
 /* Determine debug architecture. */
 u8 debug_monitors_arch(void)
@@ -223,7 +224,7 @@ static void send_user_sigtrap(int si_code)
 	if (interrupts_enabled(regs))
 		local_irq_enable();
 
-	force_sig_info(SIGTRAP, &info, current);
+	arm64_force_sig_info(&info, "User debug trap", current);
 }
 
 static int single_step_handler(unsigned long addr, unsigned int esr,

arch/arm64/kernel/ptrace.c

@@ -209,7 +209,7 @@ static void ptrace_hbptriggered(struct perf_event *bp,
 		force_sig_ptrace_errno_trap(si_errno, (void __user *)bkpt->trigger);
 	}
 #endif
-	force_sig_info(SIGTRAP, &info, current);
+	arm64_force_sig_info(&info, "Hardware breakpoint trap (ptrace)", current);
 }
 
 /*

arch/arm64/kernel/traps.c

@@ -633,11 +633,6 @@ asmlinkage void bad_el0_sync(struct pt_regs *regs, int reason, unsigned int esr)
 {
 	siginfo_t info;
 	void __user *pc = (void __user *)instruction_pointer(regs);
-	console_verbose();
-
-	pr_crit("Bad EL0 synchronous exception detected on CPU%d, code 0x%08x -- %s\n",
-		smp_processor_id(), esr, esr_get_class_string(esr));
-	__show_regs(regs);
 
 	info.si_signo = SIGILL;
 	info.si_errno = 0;
@@ -645,9 +640,9 @@ asmlinkage void bad_el0_sync(struct pt_regs *regs, int reason, unsigned int esr)
 	info.si_addr  = pc;
 
 	current->thread.fault_address = 0;
-	current->thread.fault_code = 0;
+	current->thread.fault_code = esr;
 
-	force_sig_info(info.si_signo, &info, current);
+	arm64_force_sig_info(&info, "Bad EL0 synchronous exception", current);
 }
 
 #ifdef CONFIG_VMAP_STACK