libata: don't normalize UNKNOWN to NONE after reset

After non-classifying reset, ehc->classes[] could contain
ATA_DEV_UNKNOWN which used to be normalized to ATA_DEV_NONE for
consistency.  However, this causes unfortunate side effect for drivers
which have non-classifying hardresets (e.g. sata_nv) by making
hardreset report ATA_DEV_NONE for non-classifying resets and thus
makes EH believe that the port is unoccupied and recovery can be
skipped.  The end result is that after a device is swapped with
another one, the new device isn't attached after the old one is
detached.

This patch makes ata_eh_reset() not normalize UNKNOWN to NONE after
non-classifying resets.  This fixes the above problem.  As UNKNOWN and
NONE are handled differently by only EH hotplug logic, this doesn't
cause other behavior changes.
Signed-off-by: NTejun Heo <htejun@gmail.com>
Cc: Robert Hancock <hancockr@shaw.ca>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

drivers/ata/libata-eh.c

@@ -2167,13 +2167,11 @@ int ata_eh_reset(struct ata_link *link, int classify,
 		if (ata_link_offline(link))
 			continue;
 
-		/* apply class override and convert UNKNOWN to NONE */
+		/* apply class override */
 		if (lflags & ATA_LFLAG_ASSUME_ATA)
 			classes[dev->devno] = ATA_DEV_ATA;
 		else if (lflags & ATA_LFLAG_ASSUME_SEMB)
 			classes[dev->devno] = ATA_DEV_SEMB_UNSUP; /* not yet */
-		else if (classes[dev->devno] == ATA_DEV_UNKNOWN)
-			classes[dev->devno] = ATA_DEV_NONE;
 	}
 
 	/* record current link speed */