net: stmmac: fix ethtool flow control not able to get/set

Currently ethtool was not able to get/set the flow control due to a
missing "!". It will always return -EOPNOTSUPP even the device is
flow control supported.

This patch fixes the condition check for ethtool flow control get/set
function for ETHTOOL_LINK_MODE_Asym_Pause_BIT.

Fixes: 3c1bcc86 (“net: ethernet: Convert phydev advertize and supported from u32 to link mode”)
Signed-off-by: NTan, Tee Min <tee.min.tan@intel.com>
Reviewed-by: NOng Boon Leong <boon.leong.ong@intel.com>
Signed-off-by: Voon, Weifeng <weifeng.voon@intel.com@intel.com>
Reviewed-by: NAndrew Lunn <andrew@lunn.ch>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c

@@ -460,7 +460,7 @@ stmmac_get_pauseparam(struct net_device *netdev,
 	} else {
 		if (!linkmode_test_bit(ETHTOOL_LINK_MODE_Pause_BIT,
 				       netdev->phydev->supported) ||
-		    linkmode_test_bit(ETHTOOL_LINK_MODE_Asym_Pause_BIT,
+		    !linkmode_test_bit(ETHTOOL_LINK_MODE_Asym_Pause_BIT,
 				      netdev->phydev->supported))
 			return;
 	}
@@ -491,7 +491,7 @@ stmmac_set_pauseparam(struct net_device *netdev,
 	} else {
 		if (!linkmode_test_bit(ETHTOOL_LINK_MODE_Pause_BIT,
 				       phy->supported) ||
-		    linkmode_test_bit(ETHTOOL_LINK_MODE_Asym_Pause_BIT,
+		    !linkmode_test_bit(ETHTOOL_LINK_MODE_Asym_Pause_BIT,
 				      phy->supported))
 			return -EOPNOTSUPP;
 	}