Merge tag 'fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

Pull ARM SoC fixes from Arnd Bergmann:
 "This is the final small set of ARM SoC bug fixes for linux-4.4, almost
  all regressions:

  OMAP:
   - data corruption on the Nokia N900 flash

  Allwinner:
   - Two defconfig change to get USB working again

  ARM Versatile:
   - Interrupt numbers gone bad after an older bug fix

  Nomadik:
   - Crashes from incorrect L2 cache settings

  VIA vt8500:
   - SD/MMC support on WM8650 never worked"

* tag 'fixes-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
  dts: vt8500: Add SDHC node to DTS file for WM8650
  ARM: Fix broken USB support in multi_v7_defconfig for sunxi devices
  ARM: versatile: fix MMC/SD interrupt assignment
  ARM: nomadik: set latencies to 8 cycles
  ARM: OMAP2+: Fix onenand rate detection to avoid filesystem corruption
  ARM: Fix broken USB support in sunxi_defconfig

arch/arm/boot/dts/ste-nomadik-stn8815.dtsi

@@ -25,9 +25,9 @@
 		cache-sets = <512>;
 		cache-line-size = <32>;
 		/* At full speed latency must be >=2 */
-		arm,tag-latency = <2>;
-		arm,data-latency = <2 2>;
-		arm,dirty-latency = <2>;
+		arm,tag-latency = <8>;
+		arm,data-latency = <8 8>;
+		arm,dirty-latency = <8>;
 	};
 
 	mtu0: mtu@101e2000 {

arch/arm/boot/dts/versatile-ab.dts

@@ -110,7 +110,11 @@
 			interrupt-parent = <&vic>;
 			interrupts = <31>; /* Cascaded to vic */
 			clear-mask = <0xffffffff>;
-			valid-mask = <0xffc203f8>;
+			/*
+			 * Valid interrupt lines mask according to
+			 * table 4-36 page 4-50 of ARM DUI 0225D
+			 */
+			valid-mask = <0x0760031b>;
 		};
 
 		dma@10130000 {
@@ -266,8 +270,8 @@
 			};
 			mmc@5000 {
 				compatible = "arm,pl180", "arm,primecell";
-				reg = < 0x5000 0x1000>;
-				interrupts-extended = <&vic 22 &sic 2>;
+				reg = <0x5000 0x1000>;
+				interrupts-extended = <&vic 22 &sic 1>;
 				clocks = <&xtal24mhz>, <&pclk>;
 				clock-names = "mclk", "apb_pclk";
 			};

arch/arm/boot/dts/versatile-pb.dts

@@ -5,6 +5,16 @@
 	compatible = "arm,versatile-pb";
 
 	amba {
+		/* The Versatile PB is using more SIC IRQ lines than the AB */
+		sic: intc@10003000 {
+			clear-mask = <0xffffffff>;
+			/*
+			 * Valid interrupt lines mask according to
+			 * figure 3-30 page 3-74 of ARM DUI 0224B
+			 */
+			valid-mask = <0x7fe003ff>;
+		};
+
 		gpio2: gpio@101e6000 {
 			compatible = "arm,pl061", "arm,primecell";
 			reg = <0x101e6000 0x1000>;
@@ -67,6 +77,13 @@
 		};
 
 		fpga {
+			mmc@5000 {
+				/*
+				 * Overrides the interrupt assignment from
+				 * the Versatile AB board file.
+				 */
+				interrupts-extended = <&sic 22 &sic 23>;
+			};
 			uart@9000 {
 				compatible = "arm,pl011", "arm,primecell";
 				reg = <0x9000 0x1000>;
@@ -86,7 +103,8 @@
 			mmc@b000 {
 				compatible = "arm,pl180", "arm,primecell";
 				reg = <0xb000 0x1000>;
-				interrupts-extended = <&vic 23 &sic 2>;
+				interrupt-parent = <&sic>;
+				interrupts = <1>, <2>;
 				clocks = <&xtal24mhz>, <&pclk>;
 				clock-names = "mclk", "apb_pclk";
 			};

arch/arm/boot/dts/wm8650.dtsi

@@ -187,6 +187,15 @@
 			interrupts = <43>;
 		};
 
+		sdhc@d800a000 {
+			compatible = "wm,wm8505-sdhc";
+			reg = <0xd800a000 0x400>;
+			interrupts = <20>, <21>;
+			clocks = <&clksdhc>;
+			bus-width = <4>;
+			sdon-inverted;
+		};
+
 		fb: fb@d8050800 {
 			compatible = "wm,wm8505-fb";
 			reg = <0xd8050800 0x200>;

arch/arm/configs/multi_v7_defconfig

@@ -366,6 +366,7 @@ CONFIG_BATTERY_MAX17042=m
 CONFIG_CHARGER_MAX14577=m
 CONFIG_CHARGER_MAX77693=m
 CONFIG_CHARGER_TPS65090=y
+CONFIG_AXP20X_POWER=m
 CONFIG_POWER_RESET_AS3722=y
 CONFIG_POWER_RESET_GPIO=y
 CONFIG_POWER_RESET_GPIO_RESTART=y

arch/arm/configs/sunxi_defconfig

@@ -84,6 +84,7 @@ CONFIG_SPI_SUN4I=y
 CONFIG_SPI_SUN6I=y
 CONFIG_GPIO_SYSFS=y
 CONFIG_POWER_SUPPLY=y
+CONFIG_AXP20X_POWER=y
 CONFIG_THERMAL=y
 CONFIG_CPU_THERMAL=y
 CONFIG_WATCHDOG=y

arch/arm/mach-omap2/gpmc-onenand.c

@@ -149,8 +149,8 @@ static int omap2_onenand_get_freq(struct omap_onenand_platform_data *cfg,
 		freq = 104;
 		break;
 	default:
-		freq = 54;
-		break;
+		pr_err("onenand rate not detected, bad GPMC async timings?\n");
+		freq = 0;
 	}
 
 	return freq;
@@ -271,6 +271,11 @@ static int omap2_onenand_setup_async(void __iomem *onenand_base)
 	struct gpmc_timings t;
 	int ret;
 
+	/*
+	 * Note that we need to keep sync_write set for the call to
+	 * omap2_onenand_set_async_mode() to work to detect the onenand
+	 * supported clock rate for the sync timings.
+	 */
 	if (gpmc_onenand_data->of_node) {
 		gpmc_read_settings_dt(gpmc_onenand_data->of_node,
 				      &onenand_async);
@@ -281,12 +286,9 @@ static int omap2_onenand_setup_async(void __iomem *onenand_base)
 			else
 				gpmc_onenand_data->flags |= ONENAND_SYNC_READ;
 			onenand_async.sync_read = false;
-			onenand_async.sync_write = false;
 		}
 	}
 
-	omap2_onenand_set_async_mode(onenand_base);
-
 	omap2_onenand_calc_async_timings(&t);
 
 	ret = gpmc_cs_program_settings(gpmc_onenand_data->cs, &onenand_async);
@@ -310,6 +312,8 @@ static int omap2_onenand_setup_sync(void __iomem *onenand_base, int *freq_ptr)
 	if (!freq) {
 		/* Very first call freq is not known */
 		freq = omap2_onenand_get_freq(gpmc_onenand_data, onenand_base);
+		if (!freq)
+			return -ENODEV;
 		set_onenand_cfg(onenand_base);
 	}