arm64: dts: imx8mn: correct interrupt flags

GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning:
1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
2. GPIO_ACTIVE_LOW  = 1 = IRQ_TYPE_EDGE_RISING

Correct the interrupt flags, assuming the author of the code wanted same
logical behavior behind the name "ACTIVE_xxx", this is:
  ACTIVE_LOW  => IRQ_TYPE_LEVEL_LOW

For level low interrupts, enable also internal pull up.  It is
required at least on imx8mm-evk, according to schematics.
Signed-off-by: NKrzysztof Kozlowski <krzk@kernel.org>
Acked-By: NTim Harvey <tharvey@gateworks.com>
Signed-off-by: NShawn Guo <shawnguo@kernel.org>

arch/arm64/boot/dts/freescale/imx8mn-ddr4-evk.dts

@@ -55,7 +55,7 @@
 		reg = <0x4b>;
 		pinctrl-0 = <&pinctrl_pmic>;
 		interrupt-parent = <&gpio1>;
-		interrupts = <3 GPIO_ACTIVE_LOW>;
+		interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
 		rohm,reset-snvs-powered;
 
 		regulators {

arch/arm64/boot/dts/freescale/imx8mn-evk.dts

@@ -7,6 +7,7 @@
 
 #include "imx8mn.dtsi"
 #include "imx8mn-evk.dtsi"
+#include <dt-bindings/interrupt-controller/irq.h>
 
 / {
 	model = "NXP i.MX8MNano EVK board";
@@ -19,7 +20,7 @@
 		reg = <0x25>;
 		pinctrl-0 = <&pinctrl_pmic>;
 		interrupt-parent = <&gpio1>;
-		interrupts = <3 GPIO_ACTIVE_LOW>;
+		interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
 
 		regulators {
 			buck1: BUCK1{

arch/arm64/boot/dts/freescale/imx8mn-evk.dtsi

@@ -225,7 +225,7 @@
 
 	pinctrl_pmic: pmicirqgrp {
 		fsl,pins = <
-			MX8MN_IOMUXC_GPIO1_IO03_GPIO1_IO3	0x41
+			MX8MN_IOMUXC_GPIO1_IO03_GPIO1_IO3	0x141
 		>;
 	};