net: phy: make phy_disable_interrupts() non-static

We face an issue with rtl8211f, a pin is shared between INTB and PMEB,
and the PHY Register Accessible Interrupt is enabled by default, so
the INTB/PMEB pin is always active in polling mode case.

As Heiner pointed out "I was thinking about calling
phy_disable_interrupts() in phy_init_hw(), to have a defined init
state as we don't know in which state the PHY is if the PHY driver is
loaded. We shouldn't assume that it's the chip power-on defaults, BIOS
or boot loader could have changed this. Or in case of dual-boot
systems the other OS could leave the PHY in whatever state."

Make phy_disable_interrupts() non-static so that it could be used in
phy_init_hw() to have a defined init state.
Suggested-by: NHeiner Kallweit <hkallweit1@gmail.com>
Signed-off-by: NJisheng Zhang <Jisheng.Zhang@synaptics.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/phy/phy.c

@@ -840,7 +840,7 @@ static void phy_error(struct phy_device *phydev)
  * phy_disable_interrupts - Disable the PHY interrupts from the PHY side
  * @phydev: target phy_device struct
  */
-static int phy_disable_interrupts(struct phy_device *phydev)
+int phy_disable_interrupts(struct phy_device *phydev)
 {
 	int err;
 

include/linux/phy.h

@@ -1416,6 +1416,7 @@ int phy_ethtool_ksettings_set(struct phy_device *phydev,
 int phy_mii_ioctl(struct phy_device *phydev, struct ifreq *ifr, int cmd);
 int phy_do_ioctl(struct net_device *dev, struct ifreq *ifr, int cmd);
 int phy_do_ioctl_running(struct net_device *dev, struct ifreq *ifr, int cmd);
+int phy_disable_interrupts(struct phy_device *phydev);
 void phy_request_interrupt(struct phy_device *phydev);
 void phy_free_interrupt(struct phy_device *phydev);
 void phy_print_status(struct phy_device *phydev);