提交 3cb95802 编写于 作者: K Kurt Kanzenbach 提交者: David S. Miller

net: stmmac: Fix E2E delay mechanism

When utilizing End to End delay mechanism, the following error messages show up:

|root@ehl1:~# ptp4l --tx_timestamp_timeout=50 -H -i eno2 -E -m
|ptp4l[950.573]: selected /dev/ptp3 as PTP clock
|ptp4l[950.586]: port 1: INITIALIZING to LISTENING on INIT_COMPLETE
|ptp4l[950.586]: port 0: INITIALIZING to LISTENING on INIT_COMPLETE
|ptp4l[952.879]: port 1: new foreign master 001395.fffe.4897b4-1
|ptp4l[956.879]: selected best master clock 001395.fffe.4897b4
|ptp4l[956.879]: port 1: assuming the grand master role
|ptp4l[956.879]: port 1: LISTENING to GRAND_MASTER on RS_GRAND_MASTER
|ptp4l[962.017]: port 1: received DELAY_REQ without timestamp
|ptp4l[962.273]: port 1: received DELAY_REQ without timestamp
|ptp4l[963.090]: port 1: received DELAY_REQ without timestamp

Commit f2fb6b62 ("net: stmmac: enable timestamp snapshot for required PTP
packets in dwmac v5.10a") already addresses this problem for the dwmac
v5.10. However, same holds true for all dwmacs above version v4.10. Correct the
check accordingly. Afterwards everything works as expected.

Tested on Intel Atom(R) x6414RE Processor.

Fixes: 14f34733 ("net: stmmac: Correctly take timestamp for PTPv2")
Fixes: f2fb6b62 ("net: stmmac: enable timestamp snapshot for required PTP packets in dwmac v5.10a")
Suggested-by: NOng Boon Leong <boon.leong.ong@intel.com>
Signed-off-by: NKurt Kanzenbach <kurt@linutronix.de>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 641e3fd1
......@@ -736,7 +736,7 @@ static int stmmac_hwtstamp_set(struct net_device *dev, struct ifreq *ifr)
config.rx_filter = HWTSTAMP_FILTER_PTP_V2_EVENT;
ptp_v2 = PTP_TCR_TSVER2ENA;
snap_type_sel = PTP_TCR_SNAPTYPSEL_1;
if (priv->synopsys_id != DWMAC_CORE_5_10)
if (priv->synopsys_id < DWMAC_CORE_4_10)
ts_event_en = PTP_TCR_TSEVNTENA;
ptp_over_ipv4_udp = PTP_TCR_TSIPV4ENA;
ptp_over_ipv6_udp = PTP_TCR_TSIPV6ENA;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册