habanalabs: change messages to debug level

Some messages should be changed to debug mode as we want to keep
minimal prints during normal operation of the device.
Signed-off-by: NOded Gabbay <ogabbay@kernel.org>

drivers/misc/habanalabs/common/firmware_if.c

@@ -526,7 +526,7 @@ static void fw_read_errors(struct hl_device *hdev, u32 boot_err0_reg,
 
 	security_val = RREG32(cpu_security_boot_status_reg);
 	if (security_val & CPU_BOOT_DEV_STS0_ENABLED)
-		dev_info(hdev->dev, "Device security status %#x\n",
+		dev_dbg(hdev->dev, "Device security status %#x\n",
 				security_val);
 }
 
@@ -806,7 +806,7 @@ int hl_fw_init_cpu(struct hl_device *hdev, u32 cpu_boot_status_reg,
 			hdev->asic_prop.hard_reset_done_by_fw = true;
 	}
 
-	dev_info(hdev->dev, "Firmware hard-reset is %s\n",
+	dev_dbg(hdev->dev, "Firmware hard-reset is %s\n",
 		hdev->asic_prop.hard_reset_done_by_fw ? "enabled" : "disabled");
 
 	dev_info(hdev->dev, "Successfully loaded firmware to device\n");

drivers/misc/habanalabs/gaudi/gaudi.c

@@ -1732,7 +1732,7 @@ static int gaudi_enable_msi_single(struct hl_device *hdev)
 {
 	int rc, irq;
 
-	dev_info(hdev->dev, "Working in single MSI IRQ mode\n");
+	dev_dbg(hdev->dev, "Working in single MSI IRQ mode\n");
 
 	irq = gaudi_pci_irq_vector(hdev, 0, false);
 	rc = request_irq(irq, gaudi_irq_handler_single, 0,