ixgb: fix link down initial state

As reported by Andrew Lutomirski <amluto@gmail.com>

All the intel wired ethernet drivers were calling netif_carrier_off
and netif_stop_queue (or variants) before calling register_netdevice

This is incorrect behavior as was pointed out by davem, and causes
ifconfig and friends to report a strange state before first link
after the driver was loaded, since without a netif_carrier_off, the stack
assumes carrier_on, but before register_netdev, netlink messages are not
sent out telling link state.

This apparently confused *some* versions of networkmanager.

in addition this driver appeared to need a netif_start_queue at
the end of open.
Signed-off-by: NJesse Brandeburg <jesse.brandeburg@intel.com>
Reported-by: NAndrew Lutomirski <amluto@gmail.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/ixgb/ixgb_main.c

@@ -471,10 +471,8 @@ ixgb_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 	if (err)
 		goto err_register;
 
-	/* we're going to reset, so assume we have no link for now */
-
+	/* carrier off reporting is important to ethtool even BEFORE open */
 	netif_carrier_off(netdev);
-	netif_stop_queue(netdev);
 
 	DPRINTK(PROBE, INFO, "Intel(R) PRO/10GbE Network Connection\n");
 	ixgb_check_options(adapter);
@@ -592,6 +590,8 @@ ixgb_open(struct net_device *netdev)
 	if (err)
 		goto err_setup_tx;
 
+	netif_carrier_off(netdev);
+
 	/* allocate receive descriptors */
 
 	err = ixgb_setup_rx_resources(adapter);
@@ -602,6 +602,8 @@ ixgb_open(struct net_device *netdev)
 	if (err)
 		goto err_up;
 
+	netif_start_queue(netdev);
+
 	return 0;
 
 err_up: