[SCSI] megaraid_sas: Add Online Controller Reset to MegaRAID SAS drive

To add the Online controller reset support, driver need to do:
a). reset the controller chips -- Xscale and Gen2 which will change
the function calls and add the reset function related to this two
chips.
b). during the reset, driver will store the pending cmds which not
returned by FW to driver's pending queue.  Driver will re-issue those
pending cmds again to FW after the OCR finished.
c). In driver's timeout routine, driver will report to OS as reset.
Also driver's queue routine will block the cmds until the OCR
finished.
d). in Driver's ISR routine, if driver get the FW state as state
change, FW in Failure status and FW support online controller
reset (OCR), driver will start to do the controller reset.
e). In driver's IOCTL routine, the application cmds will wait for the
OCR to finish, then issue the cmds to FW.

Signed-off-by Bo Yang <bo.yang@lsi.com>
Signed-off-by: NJames Bottomley <James.Bottomley@suse.de>

drivers/scsi/megaraid/megaraid_sas.h

@@ -60,6 +60,7 @@
 #define MFI_STATE_READY				0xB0000000
 #define MFI_STATE_OPERATIONAL			0xC0000000
 #define MFI_STATE_FAULT				0xF0000000
+#define  MFI_RESET_REQUIRED			0x00000001
 
 #define MEGAMFI_FRAME_SIZE			64
 
@@ -73,6 +74,12 @@
  * HOTPLUG	: Resume from Hotplug
  * MFI_STOP_ADP	: Send signal to FW to stop processing
  */
+#define WRITE_SEQUENCE_OFFSET		(0x0000000FC) /* I20 */
+#define HOST_DIAGNOSTIC_OFFSET		(0x000000F8)  /* I20 */
+#define DIAG_WRITE_ENABLE			(0x00000080)
+#define DIAG_RESET_ADAPTER			(0x00000004)
+
+#define MFI_ADP_RESET				0x00000040
 #define MFI_INIT_ABORT				0x00000001
 #define MFI_INIT_READY				0x00000002
 #define MFI_INIT_MFIMODE			0x00000004
@@ -402,8 +409,40 @@ struct megasas_ctrl_prop {
 	u16 ecc_bucket_leak_rate;
 	u8 restore_hotspare_on_insertion;
 	u8 expose_encl_devices;
-	u8 reserved[38];
+	u8 maintainPdFailHistory;
+	u8 disallowHostRequestReordering;
+	u8 abortCCOnError;
+	u8 loadBalanceMode;
+	u8 disableAutoDetectBackplane;
+
+	u8 snapVDSpace;
+
+	/*
+	* Add properties that can be controlled by
+	* a bit in the following structure.
+	*/
 
+	struct {
+		u32     copyBackDisabled            : 1;
+		u32     SMARTerEnabled              : 1;
+		u32     prCorrectUnconfiguredAreas  : 1;
+		u32     useFdeOnly                  : 1;
+		u32     disableNCQ                  : 1;
+		u32     SSDSMARTerEnabled           : 1;
+		u32     SSDPatrolReadEnabled        : 1;
+		u32     enableSpinDownUnconfigured  : 1;
+		u32     autoEnhancedImport          : 1;
+		u32     enableSecretKeyControl      : 1;
+		u32     disableOnlineCtrlReset      : 1;
+		u32     allowBootWithPinnedCache    : 1;
+		u32     disableSpinDownHS           : 1;
+		u32     enableJBOD                  : 1;
+		u32     reserved                    :18;
+	} OnOffProperties;
+	u8 autoSnapVDSpace;
+	u8 viewSpace;
+	u16 spinDownTime;
+	u8  reserved[24];
 } __packed;
 
 /*
@@ -704,6 +743,12 @@ struct megasas_ctrl_info {
  */
 #define IS_DMA64				(sizeof(dma_addr_t) == 8)
 
+#define MFI_XSCALE_OMR0_CHANGE_INTERRUPT		0x00000001
+
+#define MFI_INTR_FLAG_REPLY_MESSAGE			0x00000001
+#define MFI_INTR_FLAG_FIRMWARE_STATE_CHANGE		0x00000002
+#define MFI_G2_OUTBOUND_DOORBELL_CHANGE_INTERRUPT	0x00000004
+
 #define MFI_OB_INTR_STATUS_MASK			0x00000002
 #define MFI_POLL_TIMEOUT_SECS			60
 #define MEGASAS_COMPLETION_TIMER_INTERVAL      (HZ/10)
@@ -714,6 +759,9 @@ struct megasas_ctrl_info {
 #define MFI_REPLY_SKINNY_MESSAGE_INTERRUPT	0x40000000
 #define MFI_SKINNY_ENABLE_INTERRUPT_MASK	(0x00000001)
 
+#define MFI_1068_PCSR_OFFSET			0x84
+#define MFI_1068_FW_HANDSHAKE_OFFSET		0x64
+#define MFI_1068_FW_READY			0xDDDD0000
 /*
 * register set for both 1068 and 1078 controllers
 * structure extended for 1078 registers
@@ -755,8 +803,10 @@ struct megasas_register_set {
 	u32 	inbound_high_queue_port ;	/*00C4h*/
 
 	u32 	reserved_5;			/*00C8h*/
-	u32 	index_registers[820];		/*00CCh*/
-
+	u32	res_6[11];			/*CCh*/
+	u32	host_diag;
+	u32	seq_offset;
+	u32 	index_registers[807];		/*00CCh*/
 } __attribute__ ((packed));
 
 struct megasas_sge32 {
@@ -1226,11 +1276,12 @@ struct megasas_instance {
 
 	struct megasas_cmd **cmd_list;
 	struct list_head cmd_pool;
+	/* used to sync fire the cmd to fw */
 	spinlock_t cmd_pool_lock;
+	/* used to sync fire the cmd to fw */
+	spinlock_t hba_lock;
 	/* used to synch producer, consumer ptrs in dpc */
 	spinlock_t completion_lock;
-	/* used to sync fire the cmd to fw */
-	spinlock_t fire_lock;
 	struct dma_pool *frame_dma_pool;
 	struct dma_pool *sense_dma_pool;
 
@@ -1247,19 +1298,36 @@ struct megasas_instance {
 
 	struct pci_dev *pdev;
 	u32 unique_id;
+	u32 fw_support_ieee;
 
 	atomic_t fw_outstanding;
-	u32 hw_crit_error;
+	atomic_t fw_reset_no_pci_access;
 
 	struct megasas_instance_template *instancet;
 	struct tasklet_struct isr_tasklet;
+	struct work_struct work_init;
 
 	u8 flag;
 	u8 unload;
 	u8 flag_ieee;
+	u8 issuepend_done;
+	u8 disableOnlineCtrlReset;
+	u8 adprecovery;
 	unsigned long last_time;
+	u32 mfiStatus;
+	u32 last_seq_num;
 
 	struct timer_list io_completion_timer;
+	struct list_head internal_reset_pending_q;
+};
+
+enum {
+	MEGASAS_HBA_OPERATIONAL			= 0,
+	MEGASAS_ADPRESET_SM_INFAULT		= 1,
+	MEGASAS_ADPRESET_SM_FW_RESET_SUCCESS	= 2,
+	MEGASAS_ADPRESET_SM_OPERATIONAL		= 3,
+	MEGASAS_HW_CRITICAL_ERROR		= 4,
+	MEGASAS_ADPRESET_INPROG_SIGN		= 0xDEADDEAD,
 };
 
 struct megasas_instance_template {
@@ -1272,6 +1340,10 @@ struct megasas_instance_template {
 	int (*clear_intr)(struct megasas_register_set __iomem *);
 
 	u32 (*read_fw_status_reg)(struct megasas_register_set __iomem *);
+	int (*adp_reset)(struct megasas_instance *, \
+		struct megasas_register_set __iomem *);
+	int (*check_reset)(struct megasas_instance *, \
+		struct megasas_register_set __iomem *);
 };
 
 #define MEGASAS_IS_LOGICAL(scp)						\
@@ -1291,7 +1363,9 @@ struct megasas_cmd {
 	u32 index;
 	u8 sync_cmd;
 	u8 cmd_status;
-	u16 abort_aen;
+	u8 abort_aen;
+	u8 retry_for_fw_reset;
+
 
 	struct list_head list;
 	struct scsi_cmnd *scmd;