提交 38ea3686 编写于 作者: M Michael Chan 提交者: David S. Miller

[BNX2]: Disable parallel detect on an HP blade.

Because of some board issues, we need to disable parallel detect on
an HP blade.  Without this patch, the link state can become stuck
when it goes into parallel detect mode.
Signed-off-by: NMichael Chan <mchan@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 a2724e25
......@@ -5362,11 +5362,15 @@ bnx2_test_intr(struct bnx2 *bp)
return -ENODEV;
}
/* Determining link for parallel detection. */
static int
bnx2_5706_serdes_has_link(struct bnx2 *bp)
{
u32 mode_ctl, an_dbg, exp;
if (bp->phy_flags & BNX2_PHY_FLAG_NO_PARALLEL)
return 0;
bnx2_write_phy(bp, MII_BNX2_MISC_SHADOW, MISC_SHDW_MODE_CTL);
bnx2_read_phy(bp, MII_BNX2_MISC_SHADOW, &mode_ctl);
......@@ -7328,7 +7332,15 @@ bnx2_init_board(struct pci_dev *pdev, struct net_device *dev)
bp->flags |= BNX2_FLAG_NO_WOL;
bp->wol = 0;
}
if (CHIP_NUM(bp) != CHIP_NUM_5706) {
if (CHIP_NUM(bp) == CHIP_NUM_5706) {
/* Don't do parallel detect on this board because of
* some board problems. The link will not go down
* if we do parallel detect.
*/
if (pdev->subsystem_vendor == PCI_VENDOR_ID_HP &&
pdev->subsystem_device == 0x310c)
bp->phy_flags |= BNX2_PHY_FLAG_NO_PARALLEL;
} else {
bp->phy_addr = 2;
if (reg & BNX2_SHARED_HW_CFG_PHY_2_5G)
bp->phy_flags |= BNX2_PHY_FLAG_2_5G_CAPABLE;
......
......@@ -6673,6 +6673,7 @@ struct bnx2 {
#define BNX2_PHY_FLAG_DIS_EARLY_DAC 0x00000400
#define BNX2_PHY_FLAG_REMOTE_PHY_CAP 0x00000800
#define BNX2_PHY_FLAG_FORCED_DOWN 0x00001000
#define BNX2_PHY_FLAG_NO_PARALLEL 0x00002000
u32 mii_bmcr;
u32 mii_bmsr;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册