[MMC] Don't check READY_FOR_DATA when reading

There's no point checking to see if the card is ready to accept
data when we're reading from it - sending the command only wastes
precious bus bandwidth.
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

drivers/mmc/mmc_block.c

@@ -231,27 +231,29 @@ static int mmc_blk_issue_rq(struct mmc_queue *mq, struct request *req)
 			goto cmd_err;
 		}
 
-		do {
-			int err;
-
-			cmd.opcode = MMC_SEND_STATUS;
-			cmd.arg = card->rca << 16;
-			cmd.flags = MMC_RSP_R1 | MMC_CMD_AC;
-			err = mmc_wait_for_cmd(card->host, &cmd, 5);
-			if (err) {
-				printk(KERN_ERR "%s: error %d requesting status\n",
-				       req->rq_disk->disk_name, err);
-				goto cmd_err;
-			}
-		} while (!(cmd.resp[0] & R1_READY_FOR_DATA));
+		if (rq_data_dir(req) != READ) {
+			do {
+				int err;
+
+				cmd.opcode = MMC_SEND_STATUS;
+				cmd.arg = card->rca << 16;
+				cmd.flags = MMC_RSP_R1 | MMC_CMD_AC;
+				err = mmc_wait_for_cmd(card->host, &cmd, 5);
+				if (err) {
+					printk(KERN_ERR "%s: error %d requesting status\n",
+					       req->rq_disk->disk_name, err);
+					goto cmd_err;
+				}
+			} while (!(cmd.resp[0] & R1_READY_FOR_DATA));
 
 #if 0
-		if (cmd.resp[0] & ~0x00000900)
-			printk(KERN_ERR "%s: status = %08x\n",
-			       req->rq_disk->disk_name, cmd.resp[0]);
-		if (mmc_decode_status(cmd.resp))
-			goto cmd_err;
+			if (cmd.resp[0] & ~0x00000900)
+				printk(KERN_ERR "%s: status = %08x\n",
+				       req->rq_disk->disk_name, cmd.resp[0]);
+			if (mmc_decode_status(cmd.resp))
+				goto cmd_err;
 #endif
+		}
 
 		/*
 		 * A block was successfully transferred.