hwmon: add SCH5317 to smsc47b397 driver

This patch adds the SMSC SCH5317 chip (device ID 0x85) as a supported
device to the smsc47b397 driver.

Signed-off-by: Juerg Haefliger <juergh at gmail.com>
Signed-off-by: NMark M. Hoffman <mhoffman@lightlink.com>

Documentation/hwmon/smsc47b397

@@ -4,6 +4,7 @@ Kernel driver smsc47b397
 Supported chips:
   * SMSC LPC47B397-NC
   * SMSC SCH5307-NS
+  * SMSC SCH5317
     Prefix: 'smsc47b397'
     Addresses scanned: none, address read from Super I/O config space
     Datasheet: In this file
@@ -18,8 +19,8 @@ The following specification describes the SMSC LPC47B397-NC[1] sensor chip
 provided by Craig Kelly (In-Store Broadcast Network) and edited/corrected
 by Mark M. Hoffman <mhoffman@lightlink.com>.
 
-[1] And SMSC SCH5307-NS, which has a different device ID but is otherwise
-compatible.
+[1] And SMSC SCH5307-NS and SCH5317, which have different device IDs but are
+otherwise compatible.
 
 * * * * *
 
@@ -131,7 +132,7 @@ OUT	DX,AL
 The registers of interest for identifying the SIO on the dc7100 are Device ID
 (0x20) and Device Rev  (0x21).
 
-The Device ID will read 0x6F (for SCH5307-NS, 0x81)
+The Device ID will read 0x6F (0x81 for SCH5307-NS, and 0x85 for SCH5317)
 The Device Rev currently reads 0x01
 
 Obtaining the HWM Base Address.

drivers/hwmon/smsc47b397.c

@@ -333,7 +333,7 @@ static int __init smsc47b397_find(unsigned short *addr)
 	superio_enter();
 	id = superio_inb(SUPERIO_REG_DEVID);
 
-	if ((id != 0x6f) && (id != 0x81)) {
+	if ((id != 0x6f) && (id != 0x81) && (id != 0x85)) {
 		superio_exit();
 		return -ENODEV;
 	}
@@ -346,7 +346,8 @@ static int __init smsc47b397_find(unsigned short *addr)
 
 	printk(KERN_INFO DRVNAME ": found SMSC %s "
 		"(base address 0x%04x, revision %u)\n",
-		id == 0x81 ? "SCH5307-NS" : "LPC47B397-NC", *addr, rev);
+		id == 0x81 ? "SCH5307-NS" : id == 0x85 ? "SCH5317" :
+	       "LPC47B397-NC", *addr, rev);
 
 	superio_exit();
 	return 0;