mtd: m25p80: Fix 4 byte addressing mode for Micron devices.

According to the datasheet for Micron n25q256a (N25Q256A13ESF40F) 4-byte
addressing mode should be entered as follows:

<quote>
To enter or exit the 4-byte address mode, the WRITE ENABLE command
must be executed to set the write enable latch bit to 1. (Note: The
WRITE ENABLE command must NOT be executed on the N25Q256A83ESF40x and
N25Q256A83E1240x devices.) S# must be driven LOW. The effect of the
command is immediate; after the command has been executed, the write
enable latch bit is cleared to 0.
</quote>

Micron's portable way to perform this for all types of Micron flash
is to first issue a write enable, then switch the addressing mode
followed by a write disable to avoid leaving the flash in a write-
able state.
Signed-off-by: NElie De Brauwer <eliedebrauwer@email.com>
[Brian: reworked a bit]
Signed-off-by: NBrian Norris <computersforpeace@gmail.com>
Signed-off-by: NDavid Woodhouse <David.Woodhouse@intel.com>

drivers/mtd/devices/m25p80.c

@@ -168,12 +168,25 @@ static inline int write_disable(struct m25p *flash)
  */
 static inline int set_4byte(struct m25p *flash, u32 jedec_id, int enable)
 {
+	int status;
+	bool need_wren = false;
+
 	switch (JEDEC_MFR(jedec_id)) {
-	case CFI_MFR_MACRONIX:
 	case CFI_MFR_ST: /* Micron, actually */
+		/* Some Micron need WREN command; all will accept it */
+		need_wren = true;
+	case CFI_MFR_MACRONIX:
 	case 0xEF /* winbond */:
+		if (need_wren)
+			write_enable(flash);
+
 		flash->command[0] = enable ? OPCODE_EN4B : OPCODE_EX4B;
-		return spi_write(flash->spi, flash->command, 1);
+		status = spi_write(flash->spi, flash->command, 1);
+
+		if (need_wren)
+			write_disable(flash);
+
+		return status;
 	default:
 		/* Spansion style */
 		flash->command[0] = OPCODE_BRWR;