rtw88: pci: 8822c should set clock delay to zero

Since RTL8822CE has enabled reference clock auto calibration,
there is no need to add any clock delay for covering the timing
gap of the reference clock.
Signed-off-by: NYan-Hsuan Chuang <yhchuang@realtek.com>
Signed-off-by: NKalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/realtek/rtw88/pci.c

@@ -1197,11 +1197,18 @@ static void rtw_pci_link_ps(struct rtw_dev *rtwdev, bool enter)
 
 static void rtw_pci_link_cfg(struct rtw_dev *rtwdev)
 {
+	struct rtw_chip_info *chip = rtwdev->chip;
 	struct rtw_pci *rtwpci = (struct rtw_pci *)rtwdev->priv;
 	struct pci_dev *pdev = rtwpci->pdev;
 	u16 link_ctrl;
 	int ret;
 
+	/* RTL8822CE has enabled REFCLK auto calibration, it does not need
+	 * to add clock delay to cover the REFCLK timing gap.
+	 */
+	if (chip->id == RTW_CHIP_TYPE_8822C)
+		rtw_dbi_write8(rtwdev, RTK_PCIE_CLKDLY_CTRL, 0);
+
 	/* Though there is standard PCIE configuration space to set the
 	 * link control register, but by Realtek's design, driver should
 	 * check if host supports CLKREQ/ASPM to enable the HW module.

drivers/net/wireless/realtek/rtw88/pci.h

@@ -39,6 +39,7 @@
 #define RTK_PCIE_LINK_CFG	0x0719
 #define BIT_CLKREQ_SW_EN	BIT(4)
 #define BIT_L1_SW_EN		BIT(3)
+#define RTK_PCIE_CLKDLY_CTRL	0x0725
 
 #define BIT_PCI_BCNQ_FLAG	BIT(4)
 #define RTK_PCI_TXBD_DESA_BCNQ	0x308