提交 27945ebe 编写于 作者: A Andre Guedes 提交者: Jeff Kirsher

igc: Fix NFC queue redirection support

The support for ethtool Network Flow Classification (NFC) queue
redirection based on destination MAC address is currently broken in IGC.
For instance, if we add the following rule, matching frames aren't
enqueued on the expected rx queue.

$ ethtool -N IFNAME flow-type ether dst 3c:fd:fe:9e:7f:71 queue 2

The issue here is due to the fact that igc_rar_set_index() is missing
code to enable the queue selection feature from Receive Address High
(RAH) register. This patch adds the missing code and fixes the issue.
Signed-off-by: NAndre Guedes <andre.guedes@intel.com>
Acked-by: NSasha Neftin <sasha.neftin@intel.com>
Tested-by: NAaron Brown <aaron.f.brown@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
上级 2e39d2c8
无相关合并请求
......@@ -63,8 +63,11 @@
* (RAR[15]) for our directed address used by controllers with
* manageability enabled, allowing us room for 15 multicast addresses.
*/
#define IGC_RAH_QSEL_MASK 0x000C0000
#define IGC_RAH_QSEL_SHIFT 18
#define IGC_RAH_QSEL_ENABLE BIT(28)
#define IGC_RAH_AV 0x80000000 /* Receive descriptor valid */
#define IGC_RAH_POOL_1 0x00040000
#define IGC_RAL_MAC_ADDR_LEN 4
#define IGC_RAH_MAC_ADDR_LEN 2
......
......@@ -780,13 +780,18 @@ static void igc_rar_set_index(struct igc_adapter *adapter, u32 index)
rar_low = le32_to_cpup((__le32 *)(addr));
rar_high = le16_to_cpup((__le16 *)(addr + 4));
if (adapter->mac_table[index].state & IGC_MAC_STATE_QUEUE_STEERING) {
u8 queue = adapter->mac_table[index].queue;
u32 qsel = IGC_RAH_QSEL_MASK & (queue << IGC_RAH_QSEL_SHIFT);
rar_high |= qsel;
rar_high |= IGC_RAH_QSEL_ENABLE;
}
/* Indicate to hardware the Address is Valid. */
if (adapter->mac_table[index].state & IGC_MAC_STATE_IN_USE) {
if (is_valid_ether_addr(addr))
rar_high |= IGC_RAH_AV;
rar_high |= IGC_RAH_POOL_1 <<
adapter->mac_table[index].queue;
}
wr32(IGC_RAL(index), rar_low);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册
反馈
建议
客服 返回
顶部