ath10k: simplify computation of mgmt rx band

Using global channel won't work with chanctx. Try
to determine the channel from the information
provided in the wmi event itself alone. This
should be sufficient.
Signed-off-by: NMichal Kazior <michal.kazior@tieto.com>
Signed-off-by: NKalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath10k/wmi.c

@@ -1114,7 +1114,6 @@ static int ath10k_wmi_event_mgmt_rx(struct ath10k *ar, struct sk_buff *skb)
 	struct wmi_mgmt_rx_event_v2 *ev_v2;
 	struct wmi_mgmt_rx_hdr_v1 *ev_hdr;
 	struct ieee80211_rx_status *status = IEEE80211_SKB_RXCB(skb);
-	struct ieee80211_channel *ch;
 	struct ieee80211_hdr *hdr;
 	u32 rx_status;
 	u32 channel;
@@ -1167,25 +1166,26 @@ static int ath10k_wmi_event_mgmt_rx(struct ath10k *ar, struct sk_buff *skb)
 	if (rx_status & WMI_RX_STATUS_ERR_MIC)
 		status->flag |= RX_FLAG_MMIC_ERROR;
 
-	/* HW can Rx CCK rates on 5GHz. In that case phy_mode is set to
+	/* Hardware can Rx CCK rates on 5GHz. In that case phy_mode is set to
 	 * MODE_11B. This means phy_mode is not a reliable source for the band
-	 * of mgmt rx. */
-
-	ch = ar->scan_channel;
-	if (!ch)
-		ch = ar->rx_channel;
-
-	if (ch) {
-		status->band = ch->band;
-
-		if (phy_mode == MODE_11B &&
-		    status->band == IEEE80211_BAND_5GHZ)
-			ath10k_dbg(ar, ATH10K_DBG_MGMT, "wmi mgmt rx 11b (CCK) on 5GHz\n");
+	 * of mgmt rx.
+	 */
+	if (channel >= 1 && channel <= 14) {
+		status->band = IEEE80211_BAND_2GHZ;
+	} else if (channel >= 36 && channel <= 165) {
+		status->band = IEEE80211_BAND_5GHZ;
 	} else {
-		ath10k_warn(ar, "using (unreliable) phy_mode to extract band for mgmt rx\n");
-		status->band = phy_mode_to_band(phy_mode);
+		/* Shouldn't happen unless list of advertised channels to
+		 * mac80211 has been changed.
+		 */
+		WARN_ON_ONCE(1);
+		dev_kfree_skb(skb);
+		return 0;
 	}
 
+	if (phy_mode == MODE_11B && status->band == IEEE80211_BAND_5GHZ)
+		ath10k_dbg(ar, ATH10K_DBG_MGMT, "wmi mgmt rx 11b (CCK) on 5GHz\n");
+
 	status->freq = ieee80211_channel_to_frequency(channel, status->band);
 	status->signal = snr + ATH10K_DEFAULT_NOISE_FLOOR;
 	status->rate_idx = get_rate_idx(rate, status->band);