usb: dwc3: Increase timeout for CmdAct cleared by device controller

If the SS PHY is in P3, there is no pipe_clk, HW may use suspend_clk
for function, as suspend_clk is slow so EP command need more time to
complete, e.g, imx8M suspend_clk is 32K, set ep configuration will
take about 380us per below trace time stamp(44.286278 - 44.285897
= 0.000381):

configfs_acm.sh-822   [000] d..1    44.285896: dwc3_writel: addr
000000006d59aae1 value 00000401
configfs_acm.sh-822   [000] d..1    44.285897: dwc3_readl: addr
000000006d59aae1 value 00000401
... ...
configfs_acm.sh-822   [000] d..1    44.286278: dwc3_readl: addr
000000006d59aae1 value 00000001
configfs_acm.sh-822   [000] d..1    44.286279: dwc3_gadget_ep_cmd:
ep0out: cmd 'Set Endpoint Configuration' [401] params 00001000
00000500 00000000 --> status: Successful

This was originally found on Hisilicon Kirin Soc that need more time
for the device controller to clear the CmdAct of DEPCMD.
Signed-off-by: NYu Chen <chenyu56@huawei.com>
Signed-off-by: NJohn Stultz <john.stultz@linaro.org>
Signed-off-by: NLi Jun <jun.li@nxp.com>
Signed-off-by: NFelipe Balbi <balbi@kernel.org>

drivers/usb/dwc3/gadget.c

@@ -273,7 +273,7 @@ int dwc3_send_gadget_ep_cmd(struct dwc3_ep *dep, unsigned cmd,
 {
 	const struct usb_endpoint_descriptor *desc = dep->endpoint.desc;
 	struct dwc3		*dwc = dep->dwc;
-	u32			timeout = 1000;
+	u32			timeout = 5000;
 	u32			saved_config = 0;
 	u32			reg;