wlcore: use all AP basic rates as default

Sometimes we get a BSS_CHANGED_BEACON_ENABLED event before the basic
rates have been properly set.  To avoid problems with the firmware not
expecting to receive frames at rates that are not set during
CMD_START_ROLE, we now start with all basic rates by default.
Signed-off-by: NLuciano Coelho <coelho@ti.com>
Signed-off-by: NArik Nemtsov <arik@wizery.com>

drivers/net/wireless/ti/wlcore/main.c

@@ -1846,6 +1846,9 @@ static int wl12xx_init_vif_data(struct wl1271 *wl, struct ieee80211_vif *vif)
 		wl12xx_allocate_rate_policy(wl, &wlvif->sta.basic_rate_idx);
 		wl12xx_allocate_rate_policy(wl, &wlvif->sta.ap_rate_idx);
 		wl12xx_allocate_rate_policy(wl, &wlvif->sta.p2p_rate_idx);
+		wlvif->basic_rate_set = CONF_TX_RATE_MASK_BASIC;
+		wlvif->basic_rate = CONF_TX_RATE_MASK_BASIC;
+		wlvif->rate_set = CONF_TX_RATE_MASK_BASIC;
 	} else {
 		/* init ap data */
 		wlvif->ap.bcast_hlid = WL12XX_INVALID_LINK_ID;
@@ -1855,13 +1858,19 @@ static int wl12xx_init_vif_data(struct wl1271 *wl, struct ieee80211_vif *vif)
 		for (i = 0; i < CONF_TX_MAX_AC_COUNT; i++)
 			wl12xx_allocate_rate_policy(wl,
 						&wlvif->ap.ucast_rate_idx[i]);
+		wlvif->basic_rate_set = CONF_TX_AP_ENABLED_RATES;
+		/*
+		 * TODO: check if basic_rate shouldn't be
+		 * wl1271_tx_min_rate_get(wl, wlvif->basic_rate_set);
+		 * instead (the same thing for STA above).
+		*/
+		wlvif->basic_rate = CONF_TX_AP_ENABLED_RATES;
+		/* TODO: this seems to be used only for STA, check it */
+		wlvif->rate_set = CONF_TX_AP_ENABLED_RATES;
 	}
 
 	wlvif->bitrate_masks[IEEE80211_BAND_2GHZ] = wl->conf.tx.basic_rate;
 	wlvif->bitrate_masks[IEEE80211_BAND_5GHZ] = wl->conf.tx.basic_rate_5;
-	wlvif->basic_rate_set = CONF_TX_RATE_MASK_BASIC;
-	wlvif->basic_rate = CONF_TX_RATE_MASK_BASIC;
-	wlvif->rate_set = CONF_TX_RATE_MASK_BASIC;
 	wlvif->beacon_int = WL1271_DEFAULT_BEACON_INT;
 
 	/*