提交 0d0d9c15 编写于 作者: S Scott Wood 提交者: David S. Miller

fs_enet: Align receive buffers.

At least some hardware driven by this driver needs receive buffers
to be aligned on a 16-byte boundary.  This usually happens by chance,
but it breaks if slab debugging is enabled.
Signed-off-by: NScott Wood <scottwood@freescale.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>
上级 c6565331
......@@ -70,6 +70,14 @@ static void fs_set_multicast_list(struct net_device *dev)
(*fep->ops->set_multicast_list)(dev);
}
static void skb_align(struct sk_buff *skb, int align)
{
int off = ((unsigned long)skb->data) & (align - 1);
if (off)
skb_reserve(skb, align - off);
}
/* NAPI receive function */
static int fs_enet_rx_napi(struct napi_struct *napi, int budget)
{
......@@ -159,9 +167,13 @@ static int fs_enet_rx_napi(struct napi_struct *napi, int budget)
skb = skbn;
skbn = skbt;
}
} else
} else {
skbn = dev_alloc_skb(ENET_RX_FRSIZE);
if (skbn)
skb_align(skbn, ENET_RX_ALIGN);
}
if (skbn != NULL) {
skb_put(skb, pkt_len); /* Make room */
skb->protocol = eth_type_trans(skb, dev);
......@@ -290,9 +302,13 @@ static int fs_enet_rx_non_napi(struct net_device *dev)
skb = skbn;
skbn = skbt;
}
} else
} else {
skbn = dev_alloc_skb(ENET_RX_FRSIZE);
if (skbn)
skb_align(skbn, ENET_RX_ALIGN);
}
if (skbn != NULL) {
skb_put(skb, pkt_len); /* Make room */
skb->protocol = eth_type_trans(skb, dev);
......@@ -502,6 +518,7 @@ void fs_init_bds(struct net_device *dev)
dev->name);
break;
}
skb_align(skb, ENET_RX_ALIGN);
fep->rx_skbuff[i] = skb;
CBDW_BUFADDR(bdp,
dma_map_single(fep->dev, skb->data,
......
......@@ -82,7 +82,8 @@ struct phy_info {
/* Must be a multiple of 32 (to cover both FEC & FCC) */
#define PKT_MAXBLR_SIZE ((PKT_MAXBUF_SIZE + 31) & ~31)
/* This is needed so that invalidate_xxx wont invalidate too much */
#define ENET_RX_FRSIZE L1_CACHE_ALIGN(PKT_MAXBUF_SIZE)
#define ENET_RX_ALIGN 16
#define ENET_RX_FRSIZE L1_CACHE_ALIGN(PKT_MAXBUF_SIZE + ENET_RX_ALIGN - 1)
struct fs_enet_mii_bus {
struct list_head list;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册