USB: EHCI: remove wrong debug message for port speed

It displays wrong debug message if we plug in a full/low
speed device at port for builtin TT controller. We can get
device/port speed information at following code of hub_port_init,
so it is better to replace it with debug message of "reset complete".
Signed-off-by: NPeter Chen <peter.chen@freescale.com>
Acked-by: NAlan Stern <stern@rowland.harvard.edu>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/host/ehci-hub.c

@@ -536,7 +536,8 @@ static int check_reset_complete (
 		if (ehci->has_amcc_usb23)
 			set_ohci_hcfs(ehci, 1);
 	} else {
-		ehci_dbg (ehci, "port %d high speed\n", index + 1);
+		ehci_dbg(ehci, "port %d reset complete, port enabled\n",
+			index + 1);
 		/* ensure 440EPx ohci controller state is suspended */
 		if (ehci->has_amcc_usb23)
 			set_ohci_hcfs(ehci, 0);