usb: host: xhci: add a new quirk XHCI_NO_64BIT_SUPPORT

On some xHCI controllers (e.g. R-Car SoCs), the AC64 bit (bit 0) of
HCCPARAMS1 is set to 1. However, the xHCs don't support 64-bit
address memory pointers actually. So, in this case, this driver should
call dma_set_coherent_mask(dev, DMA_BIT_MASK(32)) in xhci_gen_setup().
Otherwise, the xHCI controller will be died after a usb device is
connected if it runs on above 4GB physical memory environment.

So, this patch adds a new quirk XHCI_NO_64BIT_SUPPORT to resolve
such an issue.

Cc: <stable@vger.kernel.org>
Signed-off-by: NYoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Reviewed-by: NFelipe Balbi <felipe.balbi@linux.intel.com>
Signed-off-by: NMathias Nyman <mathias.nyman@linux.intel.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/host/xhci.c

@@ -4948,6 +4948,16 @@ int xhci_gen_setup(struct usb_hcd *hcd, xhci_get_quirks_t get_quirks)
 		return retval;
 	xhci_dbg(xhci, "Reset complete\n");
 
+	/*
+	 * On some xHCI controllers (e.g. R-Car SoCs), the AC64 bit (bit 0)
+	 * of HCCPARAMS1 is set to 1. However, the xHCs don't support 64-bit
+	 * address memory pointers actually. So, this driver clears the AC64
+	 * bit of xhci->hcc_params to call dma_set_coherent_mask(dev,
+	 * DMA_BIT_MASK(32)) in this xhci_gen_setup().
+	 */
+	if (xhci->quirks & XHCI_NO_64BIT_SUPPORT)
+		xhci->hcc_params &= ~BIT(0);
+
 	/* Set dma_mask and coherent_dma_mask to 64-bits,
 	 * if xHC supports 64-bit addressing */
 	if (HCC_64BIT_ADDR(xhci->hcc_params) &&

drivers/usb/host/xhci.h

@@ -1641,6 +1641,7 @@ struct xhci_hcd {
 #define XHCI_PME_STUCK_QUIRK	(1 << 20)
 #define XHCI_MTK_HOST		(1 << 21)
 #define XHCI_SSIC_PORT_UNUSED	(1 << 22)
+#define XHCI_NO_64BIT_SUPPORT	(1 << 23)
 	unsigned int		num_active_eps;
 	unsigned int		limit_active_eps;
 	/* There are two roothubs to keep track of bus suspend info for */