[PATCH] libata: Fix a drive detection problem

The current code follows the spec but uses an overlong delay. This would
be great if the hardware did. Several vendors however forget the D7
pulldown. Fortunately 0xFF isnt a sane reset state so we can use it to
skip detection as is done in drivers/ide. (ie this is a tested solution
over a long time)
Signed-off-by: NAlan Cox <alan@redhat.com>
Signed-off-by: NJeff Garzik <jeff@garzik.org>

drivers/scsi/libata-core.c

@@ -2001,9 +2001,19 @@ static unsigned int ata_bus_softreset(struct ata_port *ap,
 	 * status is checked.  Because waiting for "a while" before
 	 * checking status is fine, post SRST, we perform this magic
 	 * delay here as well.
+	 *
+	 * Old drivers/ide uses the 2mS rule and then waits for ready
 	 */
 	msleep(150);
 
+	
+	/* Before we perform post reset processing we want to see if 
+	   the bus shows 0xFF because the odd clown forgets the D7 pulldown
+	   resistor */
+	
+	if (ata_check_status(ap) == 0xFF)
+		return 1;	/* Positive is failure for some reason */
+
 	ata_bus_post_reset(ap, devmask);
 
 	return 0;