提交 08fc5c1b 编写于 作者: V Vivek Natarajan 提交者: John W. Linville

ath9k: Enable LEDs for AR9287 chipsets.

Signed-off-by: NVivek Natarajan <vnatarajan@atheros.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
上级 d340b1f0
......@@ -454,7 +454,8 @@ struct ath_ani {
/* LED Control */
/********************/
#define ATH_LED_PIN 1
#define ATH_LED_PIN_DEF 1
#define ATH_LED_PIN_9287 8
#define ATH_LED_ON_DURATION_IDLE 350 /* in msecs */
#define ATH_LED_OFF_DURATION_IDLE 250 /* in msecs */
......
......@@ -522,6 +522,7 @@ struct ath_hw {
u32 originalGain[22];
int initPDADC;
int PDADCdelta;
u8 led_pin;
struct ar5416IniArray iniModes;
struct ar5416IniArray iniCommon;
......
......@@ -968,9 +968,9 @@ static void ath_led_blink_work(struct work_struct *work)
if ((sc->led_on_duration == ATH_LED_ON_DURATION_IDLE) ||
(sc->led_off_duration == ATH_LED_OFF_DURATION_IDLE))
ath9k_hw_set_gpio(sc->sc_ah, ATH_LED_PIN, 0);
ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin, 0);
else
ath9k_hw_set_gpio(sc->sc_ah, ATH_LED_PIN,
ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin,
(sc->sc_flags & SC_OP_LED_ON) ? 1 : 0);
ieee80211_queue_delayed_work(sc->hw,
......@@ -1002,7 +1002,7 @@ static void ath_led_brightness(struct led_classdev *led_cdev,
case LED_OFF:
if (led->led_type == ATH_LED_ASSOC ||
led->led_type == ATH_LED_RADIO) {
ath9k_hw_set_gpio(sc->sc_ah, ATH_LED_PIN,
ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin,
(led->led_type == ATH_LED_RADIO));
sc->sc_flags &= ~SC_OP_LED_ASSOCIATED;
if (led->led_type == ATH_LED_RADIO)
......@@ -1017,7 +1017,7 @@ static void ath_led_brightness(struct led_classdev *led_cdev,
ieee80211_queue_delayed_work(sc->hw,
&sc->ath_led_blink_work, 0);
} else if (led->led_type == ATH_LED_RADIO) {
ath9k_hw_set_gpio(sc->sc_ah, ATH_LED_PIN, 0);
ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin, 0);
sc->sc_flags |= SC_OP_LED_ON;
} else {
sc->led_on_cnt++;
......@@ -1062,7 +1062,7 @@ static void ath_deinit_leds(struct ath_softc *sc)
ath_unregister_led(&sc->tx_led);
ath_unregister_led(&sc->rx_led);
ath_unregister_led(&sc->radio_led);
ath9k_hw_set_gpio(sc->sc_ah, ATH_LED_PIN, 1);
ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin, 1);
}
static void ath_init_leds(struct ath_softc *sc)
......@@ -1070,11 +1070,16 @@ static void ath_init_leds(struct ath_softc *sc)
char *trigger;
int ret;
if (AR_SREV_9287(sc->sc_ah))
sc->sc_ah->led_pin = ATH_LED_PIN_9287;
else
sc->sc_ah->led_pin = ATH_LED_PIN_DEF;
/* Configure gpio 1 for output */
ath9k_hw_cfg_output(sc->sc_ah, ATH_LED_PIN,
ath9k_hw_cfg_output(sc->sc_ah, sc->sc_ah->led_pin,
AR_GPIO_OUTPUT_MUX_AS_OUTPUT);
/* LED off, active low */
ath9k_hw_set_gpio(sc->sc_ah, ATH_LED_PIN, 1);
ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin, 1);
INIT_DELAYED_WORK(&sc->ath_led_blink_work, ath_led_blink_work);
......@@ -1153,9 +1158,9 @@ void ath_radio_enable(struct ath_softc *sc)
ath9k_hw_set_interrupts(ah, sc->imask);
/* Enable LED */
ath9k_hw_cfg_output(ah, ATH_LED_PIN,
ath9k_hw_cfg_output(ah, ah->led_pin,
AR_GPIO_OUTPUT_MUX_AS_OUTPUT);
ath9k_hw_set_gpio(ah, ATH_LED_PIN, 0);
ath9k_hw_set_gpio(ah, ah->led_pin, 0);
ieee80211_wake_queues(sc->hw);
ath9k_ps_restore(sc);
......@@ -1171,8 +1176,8 @@ void ath_radio_disable(struct ath_softc *sc)
ieee80211_stop_queues(sc->hw);
/* Disable LED */
ath9k_hw_set_gpio(ah, ATH_LED_PIN, 1);
ath9k_hw_cfg_gpio_input(ah, ATH_LED_PIN);
ath9k_hw_set_gpio(ah, ah->led_pin, 1);
ath9k_hw_cfg_gpio_input(ah, ah->led_pin);
/* Disable interrupts */
ath9k_hw_set_interrupts(ah, 0);
......
......@@ -236,7 +236,7 @@ static int ath_pci_suspend(struct pci_dev *pdev, pm_message_t state)
struct ath_wiphy *aphy = hw->priv;
struct ath_softc *sc = aphy->sc;
ath9k_hw_set_gpio(sc->sc_ah, ATH_LED_PIN, 1);
ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin, 1);
pci_save_state(pdev);
pci_disable_device(pdev);
......@@ -269,9 +269,9 @@ static int ath_pci_resume(struct pci_dev *pdev)
pci_write_config_dword(pdev, 0x40, val & 0xffff00ff);
/* Enable LED */
ath9k_hw_cfg_output(sc->sc_ah, ATH_LED_PIN,
ath9k_hw_cfg_output(sc->sc_ah, sc->sc_ah->led_pin,
AR_GPIO_OUTPUT_MUX_AS_OUTPUT);
ath9k_hw_set_gpio(sc->sc_ah, ATH_LED_PIN, 1);
ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin, 1);
return 0;
}
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册