提交 037998d1 编写于 作者: A Adrian Bunk 提交者: Jeff Garzik

[PATCH] remove drivers/net/hydra.h

Remove drivers/net/hydra.h which is both unused and covered by a 4 clause
BSD licence (not by the UCB).
Signed-off-by: NAdrian Bunk <bunk@stusta.de>
Acked-By: NGeert Uytterhoeven <geert@linux-m68k.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NJeff Garzik <jeff@garzik.org>
上级 0761be4f
/* $Linux: hydra.h,v 1.0 1994/10/26 02:03:47 cgd Exp $ */
/*
* Copyright (c) 1994 Timo Rossi
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. All advertising materials mentioning features or use of this software
* must display the following acknowledgement:
* This product includes software developed by Timo Rossi
* 4. The name of the author may not be used to endorse or promote products
* derived from this software without specific prior written permission
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
* IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
* OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
* IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
* NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
* DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
* THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
* THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
/*
* The Hydra Systems card uses the National Semiconductor
* 8390 NIC (Network Interface Controller) chip, located
* at card base address + 0xffe1. NIC registers are accessible
* only at odd byte addresses, so the register offsets must
* be multiplied by two.
*
* Card address PROM is located at card base + 0xffc0 (even byte addresses)
*
* RAM starts at the card base address, and is 16K or 64K.
* The current Amiga NetBSD hydra driver is hardwired for 16K.
* It seems that the RAM should be accessed as words or longwords only.
*
*/
/* adapted for Linux by Topi Kanerva 03/29/95
with original author's permission */
#define HYDRA_NIC_BASE 0xffe1
/* Page0 registers */
#define NIC_CR 0 /* Command register */
#define NIC_PSTART (1*2) /* Page start (write) */
#define NIC_PSTOP (2*2) /* Page stop (write) */
#define NIC_BNDRY (3*2) /* Boundary pointer */
#define NIC_TSR (4*2) /* Transmit status (read) */
#define NIC_TPSR (4*2) /* Transmit page start (write) */
#define NIC_NCR (5*2) /* Number of collisions, read */
#define NIC_TBCR0 (5*2) /* Transmit byte count low (write) */
#define NIC_FIFO (6*2) /* FIFO reg. (read) */
#define NIC_TBCR1 (6*2) /* Transmit byte count high (write) */
#define NIC_ISR (7*2) /* Interrupt status register */
#define NIC_RBCR0 (0xa*2) /* Remote byte count low (write) */
#define NIC_RBCR1 (0xb*2) /* Remote byte count high (write) */
#define NIC_RSR (0xc*2) /* Receive status (read) */
#define NIC_RCR (0xc*2) /* Receive config (write) */
#define NIC_CNTR0 (0xd*2) /* Frame alignment error count (read) */
#define NIC_TCR (0xd*2) /* Transmit config (write) */
#define NIC_CNTR1 (0xe*2) /* CRC error counter (read) */
#define NIC_DCR (0xe*2) /* Data config (write) */
#define NIC_CNTR2 (0xf*2) /* missed packet counter (read) */
#define NIC_IMR (0xf*2) /* Interrupt mask reg. (write) */
/* Page1 registers */
#define NIC_PAR0 (1*2) /* Physical address */
#define NIC_PAR1 (2*2)
#define NIC_PAR2 (3*2)
#define NIC_PAR3 (4*2)
#define NIC_PAR4 (5*2)
#define NIC_PAR5 (6*2)
#define NIC_CURR (7*2) /* Current RX ring-buffer page */
#define NIC_MAR0 (8*2) /* Multicast address */
#define NIC_MAR1 (9*2)
#define NIC_MAR2 (0xa*2)
#define NIC_MAR3 (0xb*2)
#define NIC_MAR4 (0xc*2)
#define NIC_MAR5 (0xd*2)
#define NIC_MAR6 (0xe*2)
#define NIC_MAR7 (0xf*2)
/* Command register definitions */
#define CR_STOP 0x01 /* Stop -- software reset command */
#define CR_START 0x02 /* Start */
#define CR_TXP 0x04 /* Transmit packet */
#define CR_RD0 0x08 /* Remote DMA cmd */
#define CR_RD1 0x10
#define CR_RD2 0x20
#define CR_NODMA CR_RD2
#define CR_PS0 0x40 /* Page select */
#define CR_PS1 0x80
#define CR_PAGE0 0
#define CR_PAGE1 CR_PS0
#define CR_PAGE2 CR_PS1
/* Interrupt status reg. definitions */
#define ISR_PRX 0x01 /* Packet received without errors */
#define ISR_PTX 0x02 /* Packet transmitted without errors */
#define ISR_RXE 0x04 /* Receive error */
#define ISR_TXE 0x08 /* Transmit error */
#define ISR_OVW 0x10 /* Ring buffer overrun */
#define ISR_CNT 0x20 /* Counter overflow */
#define ISR_RDC 0x40 /* Remote DMA compile */
#define ISR_RST 0x80 /* Reset status */
/* Data config reg. definitions */
#define DCR_WTS 0x01 /* Word transfer select */
#define DCR_BOS 0x02 /* Byte order select */
#define DCR_LAS 0x04 /* Long address select */
#define DCR_LS 0x08 /* Loopback select */
#define DCR_AR 0x10 /* Auto-init remote */
#define DCR_FT0 0x20 /* FIFO threshold select */
#define DCR_FT1 0x40
/* Transmit config reg. definitions */
#define TCR_CRC 0x01 /* Inhibit CRC */
#define TCR_LB0 0x02 /* Loopback control */
#define TCR_LB1 0x04
#define TCR_ATD 0x08 /* Auto transmit disable */
#define TCR_OFST 0x10 /* Collision offset enable */
/* Transmit status reg. definitions */
#define TSR_PTX 0x01 /* Packet transmitted */
#define TSR_COL 0x04 /* Transmit collided */
#define TSR_ABT 0x08 /* Transmit aborted */
#define TSR_CRS 0x10 /* Carrier sense lost */
#define TSR_FU 0x20 /* FIFO underrun */
#define TSR_CDH 0x40 /* CD Heartbeat */
#define TSR_OWC 0x80 /* Out of Window Collision */
/* Receiver config register definitions */
#define RCR_SEP 0x01 /* Save errored packets */
#define RCR_AR 0x02 /* Accept runt packets */
#define RCR_AB 0x04 /* Accept broadcast */
#define RCR_AM 0x08 /* Accept multicast */
#define RCR_PRO 0x10 /* Promiscuous mode */
#define RCR_MON 0x20 /* Monitor mode */
/* Receiver status register definitions */
#define RSR_PRX 0x01 /* Packet received without error */
#define RSR_CRC 0x02 /* CRC error */
#define RSR_FAE 0x04 /* Frame alignment error */
#define RSR_FO 0x08 /* FIFO overrun */
#define RSR_MPA 0x10 /* Missed packet */
#define RSR_PHY 0x20 /* Physical address */
#define RSR_DIS 0x40 /* Received disabled */
#define RSR_DFR 0x80 /* Deferring (jabber) */
/* Hydra System card address PROM offset */
#define HYDRA_ADDRPROM 0xffc0
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册