提交 02f5dac0 编写于 作者: W Wey-Yi Guy 提交者: John W. Linville

iwlwifi: add LED mode to support different LED behavior

Today's implementation allow LED to blink based on the traffic
condition. We introduce an additional LED mode that reflects the RF
state.

The supported LED modes after this are:
  IWL_LED_BLINK (current/default) - blink rate based on current Tx/Rx
                                    traffic
  IWL_LED_RF_STATE (new) -
    LED OFF: No power/RF disabled, the LED is emitting no light
    LED ON:  Powered/RF enabled, the LED is emitting light
             in a stable non-flashing state.

In order to provide the flexibility to support different LED
behavior per user/system preference we add "led_mode" iwlcore module
parameter.
Signed-off-by: NWey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: NReinette Chatre <reinette.chatre@intel.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
上级 5953a62e
......@@ -42,6 +42,12 @@
#include "iwl-core.h"
#include "iwl-io.h"
/* default: IWL_LED_BLINK(0) using blinking index table */
static int led_mode;
module_param(led_mode, int, S_IRUGO);
MODULE_PARM_DESC(led_mode, "led mode: 0=blinking, 1=On(RF On)/Off(RF Off), "
"(default 0)\n");
#ifdef CONFIG_IWLWIFI_DEBUG
static const char *led_type_str[] = {
__stringify(IWL_LED_TRG_TX),
......@@ -199,7 +205,8 @@ static int iwl_led_off_reg(struct iwl_priv *priv, int led_id)
static int iwl_led_associate(struct iwl_priv *priv, int led_id)
{
IWL_DEBUG_LED(priv, "Associated\n");
priv->allow_blinking = 1;
if (led_mode == IWL_LED_BLINK)
priv->allow_blinking = 1;
return iwl_led_on_reg(priv, led_id);
}
static int iwl_led_disassociate(struct iwl_priv *priv, int led_id)
......
......@@ -47,6 +47,18 @@ enum led_type {
IWL_LED_TRG_RADIO,
IWL_LED_TRG_MAX,
};
/*
* LED mode
* IWL_LED_BLINK: adjust led blink rate based on blink table
* IWL_LED_RF_STATE: turn LED on/off based on RF state
* LED ON = RF ON
* LED OFF = RF OFF
*/
enum iwl_led_mode {
IWL_LED_BLINK,
IWL_LED_RF_STATE,
};
#endif
#ifdef CONFIG_IWLWIFI_LEDS
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册