SBC-4 r15 5.3 COMPARE AND WRITE command states:
  if the compare operation does not indicate a match, then terminate the
  command with CHECK CONDITION status with the sense key set to
  MISCOMPARE and the additional sense code set to MISCOMPARE DURING
  VERIFY OPERATION. In the sense data (see 4.18 and SPC-5) the offset
  from the start of the Data-Out Buffer to the first byte of data that
  was not equal shall be reported in the INFORMATION field.

This change implements the missing logic to report the miscompare offset in
the sense data INFORMATION field. As an optimization, byte-by-byte
miscompare offset calculation is only performed after memcmp() mismatch.

Link: https://lore.kernel.org/r/20201031233211.5207-5-ddiss@suse.deSigned-off-by: NDavid Disseldorp <ddiss@suse.de>
Signed-off-by: NMartin K. Petersen <martin.petersen@oracle.com>