stmmac.h 4.4 KB
Newer Older
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28
/*******************************************************************************

  Header file for stmmac platform data

  Copyright (C) 2009  STMicroelectronics Ltd

  This program is free software; you can redistribute it and/or modify it
  under the terms and conditions of the GNU General Public License,
  version 2, as published by the Free Software Foundation.

  This program is distributed in the hope it will be useful, but WITHOUT
  ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
  FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License for
  more details.

  You should have received a copy of the GNU General Public License along with
  this program; if not, write to the Free Software Foundation, Inc.,
  51 Franklin St - Fifth Floor, Boston, MA 02110-1301 USA.

  The full GNU General Public License is included in this distribution in
  the file called "COPYING".

  Author: Giuseppe Cavallaro <peppe.cavallaro@st.com>
*******************************************************************************/

#ifndef __STMMAC_PLATFORM_DATA
#define __STMMAC_PLATFORM_DATA

29 30
#include <linux/platform_device.h>

31 32 33 34
#define STMMAC_RX_COE_NONE	0
#define STMMAC_RX_COE_TYPE1	1
#define STMMAC_RX_COE_TYPE2	2

35 36 37 38 39
/* Define the macros for CSR clock range parameters to be passed by
 * platform code.
 * This could also be configured at run time using CPU freq framework. */

/* MDC Clock Selection define*/
40 41 42 43 44 45
#define	STMMAC_CSR_60_100M	0x0	/* MDC = clk_scr_i/42 */
#define	STMMAC_CSR_100_150M	0x1	/* MDC = clk_scr_i/62 */
#define	STMMAC_CSR_20_35M	0x2	/* MDC = clk_scr_i/16 */
#define	STMMAC_CSR_35_60M	0x3	/* MDC = clk_scr_i/26 */
#define	STMMAC_CSR_150_250M	0x4	/* MDC = clk_scr_i/102 */
#define	STMMAC_CSR_250_300M	0x5	/* MDC = clk_scr_i/122 */
46

47
/* The MDC clock could be set higher than the IEEE 802.3
48 49 50 51 52 53
 * specified frequency limit 0f 2.5 MHz, by programming a clock divider
 * of value different than the above defined values. The resultant MDIO
 * clock frequency of 12.5 MHz is applicable for the interfacing chips
 * supporting higher MDC clocks.
 * The MDC clock selection macros need to be defined for MDC clock rate
 * of 12.5 MHz, corresponding to the following selection.
54 55 56 57 58 59 60 61 62
 */
#define STMMAC_CSR_I_4		0x8	/* clk_csr_i/4 */
#define STMMAC_CSR_I_6		0x9	/* clk_csr_i/6 */
#define STMMAC_CSR_I_8		0xA	/* clk_csr_i/8 */
#define STMMAC_CSR_I_10		0xB	/* clk_csr_i/10 */
#define STMMAC_CSR_I_12		0xC	/* clk_csr_i/12 */
#define STMMAC_CSR_I_14		0xD	/* clk_csr_i/14 */
#define STMMAC_CSR_I_16		0xE	/* clk_csr_i/16 */
#define STMMAC_CSR_I_18		0xF	/* clk_csr_i/18 */
63

64
/* AXI DMA Burst length supported */
65 66 67 68 69 70 71 72 73 74 75
#define DMA_AXI_BLEN_4		(1 << 1)
#define DMA_AXI_BLEN_8		(1 << 2)
#define DMA_AXI_BLEN_16		(1 << 3)
#define DMA_AXI_BLEN_32		(1 << 4)
#define DMA_AXI_BLEN_64		(1 << 5)
#define DMA_AXI_BLEN_128	(1 << 6)
#define DMA_AXI_BLEN_256	(1 << 7)
#define DMA_AXI_BLEN_ALL (DMA_AXI_BLEN_4 | DMA_AXI_BLEN_8 | DMA_AXI_BLEN_16 \
			| DMA_AXI_BLEN_32 | DMA_AXI_BLEN_64 \
			| DMA_AXI_BLEN_128 | DMA_AXI_BLEN_256)

76 77 78 79 80 81 82
/* Platfrom data for platform device structure's platform_data field */

struct stmmac_mdio_bus_data {
	int (*phy_reset)(void *priv);
	unsigned int phy_mask;
	int *irqs;
	int probed_phy_irq;
83 84 85 86
#ifdef CONFIG_OF
	int reset_gpio, active_low;
	u32 delays[3];
#endif
87
};
88

89 90 91
struct stmmac_dma_cfg {
	int pbl;
	int fixed_burst;
92
	int mixed_burst;
93 94 95 96 97 98 99 100 101 102 103 104 105 106 107
	bool aal;
};

#define AXI_BLEN	7
struct stmmac_axi {
	bool axi_lpi_en;
	bool axi_xit_frm;
	u32 axi_wr_osr_lmt;
	u32 axi_rd_osr_lmt;
	bool axi_kbbe;
	bool axi_axi_all;
	u32 axi_blen[AXI_BLEN];
	bool axi_fb;
	bool axi_mb;
	bool axi_rb;
108 109
};

110 111
struct plat_stmmacenet_data {
	int bus_id;
112 113 114
	int phy_addr;
	int interface;
	struct stmmac_mdio_bus_data *mdio_bus_data;
115
	struct device_node *phy_node;
G
Giuseppe CAVALLARO 已提交
116
	struct device_node *mdio_node;
117
	struct stmmac_dma_cfg *dma_cfg;
118
	int clk_csr;
119
	int has_gmac;
120
	int enh_desc;
121
	int tx_coe;
122
	int rx_coe;
123
	int bugged_jumbo;
124
	int pmt;
125
	int force_sf_dma_mode;
126
	int force_thresh_dma_mode;
127
	int riwt_off;
128
	int max_speed;
129
	int maxmtu;
130 131
	int multicast_filter_bins;
	int unicast_filter_entries;
132 133
	int tx_fifo_size;
	int rx_fifo_size;
134
	void (*fix_mac_speed)(void *priv, unsigned int speed);
135
	void (*bus_setup)(void __iomem *ioaddr);
136 137
	int (*init)(struct platform_device *pdev, void *priv);
	void (*exit)(struct platform_device *pdev, void *priv);
138 139
	void (*suspend)(struct platform_device *pdev, void *priv);
	void (*resume)(struct platform_device *pdev, void *priv);
140
	void *bsp_priv;
141
	struct stmmac_axi *axi;
142 143
	int has_gmac4;
	bool tso_en;
144 145
};
#endif