- 06 10月, 2014 1 次提交
-
-
由 Petri Gynther 提交于
bcmgenet_mii_setup() is called from the PHY state machine every 1-2 seconds when the PHYs are in PHY_POLL mode. Improve bcmgenet_mii_setup() so that it touches the MAC registers only when the link is up and there was a change to link, speed, duplex, or pause status. Signed-off-by: NPetri Gynther <pgynther@google.com> Tested-by: NFlorian Fainelli <f.fainelli@gmail.com> Acked-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 20 9月, 2014 1 次提交
-
-
由 Florian Fainelli 提交于
The integrated BCM7xxx PHY contains no useful revision information in its MII_PHYSID2 bits 3:0, that information is instead contained in the GENET hardware block. We already read the GENET 32-bit revision register, so store the integrated PHY revision in the driver private structure, and then communicate this revision value to the PHY driver by overriding the phy_flags value. Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 24 7月, 2014 2 次提交
-
-
由 Florian Fainelli 提交于
checkpatch.pl flagged a lot of "CHECK: Alignment should match open parenthesis" checks, fix all of them to make the driver neater. While at it fix some obvious typos and re-arrange some of the lines to avoid going over 80 columns. Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Florian Fainelli 提交于
Use a smaller GPLv2 header and remove all the boilerplate code as well as the FSF mail address. Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 22 7月, 2014 3 次提交
-
-
由 Florian Fainelli 提交于
Add all the required code to program the GENET hardware to enter Wake-on-LAN mode and wake using MagicPackets with or without SecureOn password. This code is hooked to the build system, but is not yet referenced from ethtool or the main bcmgenet driver. Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Florian Fainelli 提交于
Attempt to the request the Wake-on-LAN interrupt bit, and if successful, advertise wakeup capability instead of doing this unconditionnally. Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Florian Fainelli 提交于
Checking for wol_enabled in bcmgenet_close() is bogus, since no other code places set priv->wol_enabled. Remove that as it will conflict with the upcoming and functional Wake-on-LAN implementation. Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 14 7月, 2014 1 次提交
-
-
由 Florian Fainelli 提交于
RGMII_MODE_EN bit was defined to 0, while it is actually 6. It was not much of a problem on older designs where this was a no-op, and the RGMII data-path would always be enabled, but newer GENET controllers need to explicitely enable their RGMII data-pad using this bit. Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 21 3月, 2014 1 次提交
-
-
由 Florian Fainelli 提交于
The spinlock cookie in bcmgenet_priv is never used, get rid of it. Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 25 2月, 2014 1 次提交
-
-
由 Florian Fainelli 提交于
bh_lock spinlock is unused, remove it from the private driver structure. Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 14 2月, 2014 1 次提交
-
-
由 Florian Fainelli 提交于
This patchs adds the bcmgenet.h header file which contains all the hardware definitions for the GENETv1 to v4 hardware blocks as well as the driver private structure and MIB counters. Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-