This should help to interpret user reports.  E.g. one can look up the
vendor OUI (first three bytes of the GUID) and thus tell what is what.

Also simplifies the math in the GUID sysfs attribute.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>
Signed-off-by: NJarod Wilson <jwilson@redhat.com>

There is a race between shutdown and creation of devices:  fw-core may
attempt to add a device with the same name of an already existing
device.  http://bugzilla.kernel.org/show_bug.cgi?id=9828

Impact of the bug:  Happens rarely (when shutdown of a device coincides
with creation of another), forces the user to unplug and replug the new
device to get it working.

The fix is obvious:  Free the minor number *after* instead of *before*
device_unregister().  This requires to take an additional reference of
the fw_device as long as the IDR tree points to it.

And while we are at it, we fix an additional race condition:
fw_device_op_open() took its reference of the fw_device a little bit too
late, hence was in danger to access an already invalid fw_device.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

read_rom() obtained a fresh new fw_device.generation for each read
transaction.  Hence it was able to continue reading in the middle of the
ROM even if a bus reset happened.  However the device may have modified
the ROM during the reset.  We would end up with a corrupt fetched ROM
image then.

Although all of this is quite unlikely, it is not impossible.
Therefore we now restart reading the ROM if the bus generation changed.

Note, the memory barrier in read_rom() is still necessary according to
tests by Jarod Wilson, despite of the ->generation access being moved up
in the call chain.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

This is essentially what I've been beating on locally, and I've yet to hit
another config rom read failure with it.
Signed-off-by: NJarod Wilson <jwilson@redhat.com>

fw_device.node_id and fw_device.generation are accessed without mutexes.
We have to ensure that all readers will get to see node_id updates
before generation updates.

Fixes an inability to recognize devices after "giving up on config rom",
https://bugzilla.redhat.com/show_bug.cgi?id=429950Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Reviewed by Nick Piggin <nickpiggin@yahoo.com.au>.

Verified to fix 'giving up on config rom' issues on multiple system and
drive combinations that were previously affected.
Signed-off-by: NJarod Wilson <jwilson@redhat.com>
Signed-off-by: NKristian Høgsberg <krh@redhat.com>

This changes the uevent buffer functions to use a struct instead of a
long list of parameters. It does no longer require the caller to do the
proper buffer termination and size accounting, which is currently wrong
in some places. It fixes a known bug where parts of the uevent
environment are overwritten because of wrong index calculations.

Many thanks to Mathieu Desnoyers for finding bugs and improving the
error handling.
Signed-off-by: NKay Sievers <kay.sievers@vrfy.org>
Cc: Mathieu Desnoyers <mathieu.desnoyers@polymtl.ca>
Cc: Cornelia Huck <cornelia.huck@de.ibm.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

Use a speed probe to determine the speed over 1394b buses and of nodes
which report a link speed less than their PHY speed.

Log the effective maximum speed of newly created nodes in dmesg.

Also, read the config ROM (except bus info block) at the maximum speed
rather than S100.  This isn't a real optimization though because we
still only use quadlet read requests for the entire ROM.

The patch also adds support for S1600 and S3200, although such hardware
does not exist yet.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>
Signed-off-by: NKristian Høgsberg <krh@redhat.com>

Signed-off-by: NKristian Hoegsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Drop filenames from file preamble, drop editor annotations and
use standard indent style for block comments.
Signed-off-by: NKristian Hoegsberg <krh@redhat.com>
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de> (fixed typo)

Make firewire entry points not 'extern':

drivers/firewire/fw-device.c:160:25: warning: function 'fw_device_get' with external linkage has definition
drivers/firewire/fw-device.c:167:13: warning: function 'fw_device_put' with external linkage has definition
Signed-off-by: NRandy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

You don't know what type is used to implement u64.
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Some devices have a really long power-on cycle, and we fail to
successfully probe these if they're plugged in and then turned on.

There's really no down-side to bumping the number of retries and the
retry delay, and most devices will get picked up within the first couple
of retries anyway.
Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

We dynamically create an attribute group for the key present on the
device in hand and point device->group to it.  This way the device
core adds the sysfs attributes for us as the device is added.
Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

We export the entire config rom, so this is technically redundant,
but should make udev rules and HAL integration easier.
Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

The device_type struct is useful for setting attributes for a device
and overriding .release and .uevent for a group of devices.  This patch
uses it this way to clean up the sysfs code a bit.
Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>
Signed-off-by: NKristian Høgsberg <krh@redhat.com>

as a precaution.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

This serializes the update callback with the probe and remove callback from
the driver core and prevents remove from being called while update is
running for the same device.
Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Drop the event list semaphore and only use the wait queue and the list
to synchronize queue access.  Break out of a poll or read whenever
the device is disconnected.
Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

The old mechanism kept a struct cdev for each fw device, but fops->release
would reference this struct after the device got freed in some cases.
Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

We can't take the klist lock for the child device list in interrupt
context.
Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Remove space before tab and trailing whitespace.
Unify indentation of goto target labels.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NKristian Høgsberg <krh@redhat.com>

Use atomic_inc_return.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Definitions as per IEEE 1212 and IEEE 1394:

     Node ID: Concatenation of bus ID and local ID. 16 bits long.
      Bus ID: Identifies a particular bus within a group of buses
              interconnected by bus bridges.
    Local ID: Identifies a particular node on a bus.
      PHY ID: Local ID of IEEE 1394 nodes. 6 bits long.

Never ever use a variable called node_id for anything else than a node ID.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>
Signed-off-by: NKristian Høgsberg <krh@redhat.com>

Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>
Signed-off-by: NKristian Høgsberg <krh@redhat.com>

Instances of struct file_operations and struct fw_card_driver can be
qualified as "const".  Ditto with struct fw_descriptor.data, struct
fw_device_id, and predefined instances of struct fw_address_region,
at least in the current implementation.

Data qualified as const is placed into the .rodata section which won't
be mixed with dirty data.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NKristian Høgsberg <krh@redhat.com>
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>