- 10 12月, 2006 1 次提交
-
-
由 Yan Burman 提交于
Replace kmalloc+memset with kzalloc Signed-off-by: NYan Burman <burman.yan@gmail.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 27 10月, 2006 1 次提交
-
-
由 David S. Miller 提交于
dp->path_component_name can be larger than ->bus_id[] so use a different naming scheme for this stuff. Noticed by Jurij Smakov. Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 30 6月, 2006 2 次提交
-
-
由 David S. Miller 提交于
Do IRQ determination generically by parsing the PROM properties, and using IRQ controller drivers for final resolution. One immediate positive effect is that all of the IRQ frobbing in the EBUS, ISA, and PCI controller layers has been eliminated. We just look up the of_device and use the properly computed value. The PCI controller irq_build() routines are gone and no longer used. Unfortunately sbus_build_irq() has to remain as there is a direct reference to this in the sunzilog driver. That can be killed off once the sparc32 side of this is written and the sunzilog driver is transformed into an "of" bus driver. Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 David S. Miller 提交于
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 24 6月, 2006 4 次提交
-
-
由 David S. Miller 提交于
Sparcspkr and power drivers are converted, to make sure it works. Eventually the SBUS device layer will use this as a sub-class. I really cannot cut loose on that bit until sparc32 is given the same infrastructure. Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 David S. Miller 提交于
Unused outside of initial bus probe scan. Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 David S. Miller 提交于
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 David S. Miller 提交于
One thing this change pointed out was that we really should pull the "get 'local-mac-address' property" logic into a helper function all the network drivers can call. Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 17 4月, 2005 1 次提交
-
-
由 Linus Torvalds 提交于
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
-