This patch reserves the EFI memory map with reserve_early(). Because EFI
memory map is allocated by bootloader, if it is not reserved by
reserved_early(), it may be overwritten through address returned by
find_e820_area().
Signed-off-by: NHuang Ying <ying.huang@intel.com>
Cc: andi@firstfloor.org
Cc: mingo@redhat.com
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

This patch makes early reserved highmem pages become reserved
pages. This can be used for highmem pages allocated by bootloader such
as EFI memory map, linked list of setup_data, etc.
Signed-off-by: NHuang Ying <ying.huang@intel.com>
Cc: andi@firstfloor.org
Cc: mingo@redhat.com
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

This patch clean up reserve_early() family functions by extracting the
common part of reserve_early(), free_early() and bad_addr() into
find_overlapped_early().
Signed-off-by: NHuang Ying <ying.huang@intel.com>
Cc: andi@firstfloor.org
Cc: mingo@redhat.com
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

should use right shift
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Cc: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

this way 32-bit is more similar to 64-bit, and smarter e820 and numa.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

to prepare 32-bit to use it.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

when 1/3 user/kernel split is used, and less memory is installed, or if
we have a big hole below 4g, max_low_pfn is still using 3g-128m

try to go down from max_low_pfn until we get it. otherwise will panic.

need to make 32-bit code to use register_e820_active_regions ... later.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

so we could fall back to one node numa.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

add memory_present() calls for sparse and non-numa.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

on 64-bit we only get valid max_pfn_mapped after init_memory_mapping().
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

on 32-bit in head_32.S after initial page table is done, we get initial
max_pfn_mapped, and then kernel_physical_mapping_init will give us
a final one.

We need to use that to make sure find_e820_area will get valid addresses
for boot_map and for NODE_DATA(0) on numa32.

XEN PV and lguest may need to assign max_pfn_mapped too.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

use find_e820_area to get address space...
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

make mptable to be consistent with acpi routing, so we could:

1. kexec kernel with acpi=off
2. work around BIOSes where acpi routing is working, but mptable is
   not right, so can use kernel/kexec to start other OSes that don't have
   good acpi support.

command line: update_mptable
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

also fix the print out of node_remap_end_vaddr
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

we don't need to call memory_present that early.
numa and sparse will call memory_present later and might
even fail, it will call memory_present for the full range.

also for sparse it will call alloc_bootmem ... before we set up bootmem.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

... otherwise alloc_remap will not get node_mem_map from kva area, and
alloc_node_mem_map has to alloc_bootmem_node to get mem_map.
It will use two low address copies ...
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

so every element will represent 64M instead of 256M.

AMD opteron could have HW memory hole remapping, so could have
[0, 8g + 64M) on node0. Reduce element size to 64M to keep that on node 0

Later we need to use find_e820_area() to allocate memory_node_map like
on 64-bit. But need to move memory_present out of populate_mem_map...
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

on two node system (16g RAM) with numa config I got this crash:

get_memcfg_from_srat: assigning address to rsdp
RSD PTR  v0 [ACPIAM]
ACPI: Too big length in RSDT: 92
failed to get NUMA memory information from SRAT table
NUMA - single node, flat memory mode
Node: 0, start_pfn: 0, end_pfn: 153
 Setting physnode_map array to node 0 for pfns:
 0
...
Pid: 0, comm: swapper Not tainted 2.6.26-rc4 #4
 [<80b41289>] hlt_loop+0x0/0x3
 [<8011efa0>] ? alloc_remap+0x50/0x70
 [<8079e32e>] alloc_node_mem_map+0x5e/0xa0
 [<8012e77b>] ? printk+0x1b/0x20
 [<80b590f6>] free_area_init_node+0xc6/0x470
 [<80b588fc>] ? __alloc_bootmem_node+0x2c/0x50
 [<80b58ad8>] ? find_min_pfn_for_node+0x38/0x70
 [<8012e77b>] ? printk+0x1b/0x20
 [<80b597c4>] free_area_init_nodes+0x254/0x2d0
 [<80b544d7>] zone_sizes_init+0x97/0xa0
 [<80b48a03>] setup_arch+0x383/0x530
 [<8012e77b>] ? printk+0x1b/0x20
 [<80b41aa4>] start_kernel+0x64/0x350
 [<80b412d8>] i386_start_kernel+0x8/0x10
 =======================

this patch increases the acpi table limit to 32.
Also match early_ioremap() with early_iounmap().
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

reserve early numa kva, so it will not clash with new RAMDISK
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

reserve_early pgdata for 32bit numa
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

introduce init_pg_table_start, so xen PV could specify the value.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

remove extra -1 in reseve_early calling
    panic if can not find space for new RAMDISK
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Cc: Andrew Morton <akpm@linux-foundation.org>
Cc: Jeremy Fitzhardinge <jeremy@goop.org>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

UP builds with LOCAL_APIC=y and IO_APIC=n fail with a missing
reference to mp_bus_not_pci. Distangle the mpparse code some more and
move the ioapic specific bus check into a separate function.

This code needs sume urgent un#ifdef surgery all over the place.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

and make e820_mark_nosave_regions to take limit_pfn to use max_low_pfn
for 32bit and end_pfn for 64bit
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Cc: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Sitsofe Wheeler reported boot problems on linux-next.

It looks like the same issue as found by Soeren Sandman in 7575217f656a93,
"x86: initialize all fields of mp_irqs[mp_irq_entries]".

But his fix is also not complete, as dstapic is used before it assigned.
Reported-by: NSitsofe Wheeler <sitsofe@yahoo.com>
Bisected-by: NSitsofe Wheeler <sitsofe@yahoo.com>
Signed-off-by: NAlexey Starikovskiy <astarikovskiy@suse.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Commit "x86: make config_irqsrc not MPspec specific" introduced some uses
of uninitialized fields in mp_config_acpi_legacy_irqs(). I need the
following patch to get sched-devel/master to boot.
Signed-off-by: NIngo Molnar <mingo@elte.hu>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

Signed-off-by: NAlexey Starikovskiy <astarikovskiy@suse.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Signed-off-by: NAlexey Starikovskiy <astarikovskiy@suse.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Signed-off-by: NAlexey Starikovskiy <astarikovskiy@suse.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Signed-off-by: NAlexey Starikovskiy <astarikovskiy@suse.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Signed-off-by: NAlexey Starikovskiy <astarikovskiy@suse.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

the new output is:

 MPTABLE: OEM ID: SUN
 MPTABLE: Product ID: 4600 M2
 MPTABLE: APIC at: 0x

instead of it all in one line with <6> and double Product ID...
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>

global pci_mem_start needs a declaration. include pci.h
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>