Under arm64 elf_hwcap is a 32 bit quantity, but it is stored in
a 64 bit auxiliary ELF field and glibc reads hwcap as 64 bit.

This patch widens elf_hwcap to be 64 bit.
Signed-off-by: NSteve Capper <steve.capper@arm.com>
Signed-off-by: NCatalin Marinas <catalin.marinas@arm.com>

We always use a timer-backed delay loop for arm64, so don't bother
reporting a bogomips value which appears to confuse some people.
Signed-off-by: NWill Deacon <will.deacon@arm.com>
Signed-off-by: NCatalin Marinas <catalin.marinas@arm.com>

Most architectures use the same implementation. Collapse the common ones
into a single weak function that can be overridden.
Signed-off-by: NGrant Likely <grant.likely@linaro.org>

The of_platform_populate() is currently invoked at device_initcall()
level. There are however drivers that use platform_driver_probe()
directly and they need the devices to be populated. This patch makes the
of_platform_populate() and arch_initcall().
Signed-off-by: NCatalin Marinas <catalin.marinas@arm.com>
Reported-by: NBenoit Lecardonnel <Benoit.Lecardonnel@synopsys.com>
Tested-by: NBenoit Lecardonnel <Benoit.Lecardonnel@synopsys.com>

When booting the kernel, the cpu logical id map must be initialised
using device tree data passed by FW or through an embedded blob.

This patch parses the reg property in device tree "cpu" nodes,
retrieves the corresponding CPUs hardware identifiers (MPIDR) and
initialises the cpu logical map accordingly.

The device tree HW identifiers are considered valid if all CPU nodes
contain a "reg" property, there are no duplicate "reg" entries and the
DT defines a CPU node whose "reg" property defines affinity levels
that matches those of the boot CPU.

The primary CPU is assigned cpu logical number 0 to keep the current
convention valid.

Based on a0ae0240 (ARM: kernel: add
device tree init map function).
Signed-off-by: NJavi Merino <javi.merino@arm.com>
Signed-off-by: NCatalin Marinas <catalin.marinas@arm.com>

This patch adds an arch_initcall() for the of_clk_init() clock
initialisation.
Signed-off-by: NCatalin Marinas <catalin.marinas@arm.com>

This patch adds support for the Power State Coordination Interface
defined by ARM, allowing Linux to request CPU-centric power-management
operations from firmware implementing the PSCI protocol.
Signed-off-by: NWill Deacon <will.deacon@arm.com>
[Marc: s/u32/u64/ in the relevant spots, and switch from an initcall
 to an simpler init function]
Signed-off-by: NMarc Zyngier <marc.zyngier@arm.com>
Signed-off-by: NCatalin Marinas <catalin.marinas@arm.com>

This patch add a device_initcall() to populate the platform devices
(of_default_bus_match_table). This allows SoC implementations that do
not require earlier initcalls to avoid any platform-specific code under
arch/arm64.

GIC and generic timer initialisation is done via FDT and CPU notifiers
independently of the SoC code.
Signed-off-by: NCatalin Marinas <catalin.marinas@arm.com>
Acked-by: NArnd Bergmann <arnd@arndb.de>

According to Documentation/arm64/booting.txt, the kernel image must be
loaded at a pre-defined offset from the start of RAM so that the kernel
can calculate PHYS_OFFSET based on this address. If the DT contains
memory blocks below this PHYS_OFFSET, report them and ignore the
corresponding memory range.
Signed-off-by: NCatalin Marinas <catalin.marinas@arm.com>

The patch adds the kernel booting and the initial setup code.
Documentation/arm64/booting.txt describes the booting protocol on the
AArch64 Linux kernel. This is subject to change following the work on
boot standardisation, ACPI.
Signed-off-by: NWill Deacon <will.deacon@arm.com>
Signed-off-by: NCatalin Marinas <catalin.marinas@arm.com>
Acked-by: NNicolas Pitre <nico@linaro.org>
Acked-by: NTony Lindgren <tony@atomide.com>
Acked-by: NOlof Johansson <olof@lixom.net>
Acked-by: NSantosh Shilimkar <santosh.shilimkar@ti.com>
Acked-by: NArnd Bergmann <arnd@arndb.de>